[PATCH] ARM: dts: kswitch-d10: use open drain mode for coma-mode pins

[Michael Walle]

The driver use the coma-mode pins as open-drain. Flag them in the device
tree accordingly. This avoids the following error:
[   14.114180] gpio-2007 (coma-mode): enforced open drain please flag it properly in DT/ACPI DSDT/board file

Fixes: 46a9556d977e ("ARM: dts: kswitch-d10: enable networking")
Signed-off-by: Michael Walle <michael@xxxxxxxx>
---
 arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi b/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
index 949d49944a37..5a6c5f7c371a 100644
--- a/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
+++ b/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
@@ -87,22 +87,22 @@ &mdio0 {
 
 	phy4: ethernet-phy@5 {
 		reg = <5>;
-		coma-mode-gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+		coma-mode-gpios = <&gpio 37 GPIO_OPEN_DRAIN>;
 	};
 
 	phy5: ethernet-phy@6 {
 		reg = <6>;
-		coma-mode-gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+		coma-mode-gpios = <&gpio 37 GPIO_OPEN_DRAIN>;
 	};
 
 	phy6: ethernet-phy@7 {
 		reg = <7>;
-		coma-mode-gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+		coma-mode-gpios = <&gpio 37 GPIO_OPEN_DRAIN>;
 	};
 
 	phy7: ethernet-phy@8 {
 		reg = <8>;
-		coma-mode-gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+		coma-mode-gpios = <&gpio 37 GPIO_OPEN_DRAIN>;
 	};
 };
 
-- 
2.30.2