[PATCH v4 6/7] ARM: dts: sun8i: a83t: Add MIPI CSI-2 controller node

From: Paul Kocialkowski
Date: Wed May 25 2022 - 14:59:42 EST


MIPI CSI-2 is supported on the A83T with a dedicated controller that
covers both the protocol and D-PHY. It can be connected to the CSI
interface as a V4L2 subdev through the fwnode graph.

This is not done by default since connecting the bridge without a
subdev attached to it will cause a failure on the CSI driver.

Signed-off-by: Paul Kocialkowski <paul.kocialkowski@xxxxxxxxxxx>
---
arch/arm/boot/dts/sun8i-a83t.dtsi | 26 ++++++++++++++++++++++++++
1 file changed, 26 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-a83t.dtsi b/arch/arm/boot/dts/sun8i-a83t.dtsi
index 82fdb04122ca..ecf9f3b2c0c0 100644
--- a/arch/arm/boot/dts/sun8i-a83t.dtsi
+++ b/arch/arm/boot/dts/sun8i-a83t.dtsi
@@ -1064,6 +1064,32 @@ csi: camera@1cb0000 {
status = "disabled";
};

+ mipi_csi2: csi@1cb1000 {
+ compatible = "allwinner,sun8i-a83t-mipi-csi2";
+ reg = <0x01cb1000 0x1000>;
+ interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&ccu CLK_BUS_CSI>,
+ <&ccu CLK_CSI_SCLK>,
+ <&ccu CLK_MIPI_CSI>,
+ <&ccu CLK_CSI_MISC>;
+ clock-names = "bus", "mod", "mipi", "misc";
+ resets = <&ccu RST_BUS_CSI>;
+ status = "disabled";
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ mipi_csi2_in: port@0 {
+ reg = <0>;
+ };
+
+ mipi_csi2_out: port@1 {
+ reg = <1>;
+ };
+ };
+ };
+
hdmi: hdmi@1ee0000 {
compatible = "allwinner,sun8i-a83t-dw-hdmi";
reg = <0x01ee0000 0x10000>;
--
2.36.1