Re: [PATCH v3] net: phy: DP83822: enable rgmii mode if phy_interface_is_rgmii

[Andrew Lunn]

On Mon, May 23, 2022 at 08:57:54AM +0200, Tommaso Merciai wrote:
> On Sat, May 21, 2022 at 08:39:02PM +0200, Andrew Lunn wrote:
> > On Sat, May 21, 2022 at 01:58:46AM +0200, Tommaso Merciai wrote:
> > > RGMII mode can be enable from dp83822 straps, and also writing bit 9
> > > of register 0x17 - RMII and Status Register (RCSR).
> > > When phy_interface_is_rgmii rgmii mode must be enabled, same for
> > > contrary, this prevents malconfigurations of hw straps
> > > 
> > > References:
> > >  - https://www.ti.com/lit/gpn/dp83822i p66
> > > 
> > > Signed-off-by: Tommaso Merciai <tommaso.merciai@xxxxxxxxxxxxxxxxxxxx>
> > > Co-developed-by: Michael Trimarchi <michael@xxxxxxxxxxxxxxxxxxxx>
> > > Suggested-by: Alberto Bianchi <alberto.bianchi@xxxxxxxxxxxxxxxxxxxx>
> > > Tested-by: Tommaso Merciai <tommaso.merciai@xxxxxxxxxxxxxxxxxxxx>
> > 
> > Reviewed-by: Andrew Lunn <andrew@xxxxxxx>
> > 
> > If you want to, you could go further. If bit 9 is clear, bit 5 defines
> > the mode, either RMII or MII. There are interface modes defined for
> > these, so you could get bit 5 as well.
> 
> Hi Andrew,
> Thanks for the review and for your time.
> I'll try to go further, like you suggest :)

Hi Tomaso

This patch has been accepted, so you will need to submit an
incremental patch. I also expect net-next to close soon for the merge
window, so you might want to wait two weeks before submitting.

	Andrew