Re: [PATCH v2] arm64: dts: imx8mm-evk: add pwm1/backlight support

From: Tommaso Merciai
Date: Wed Apr 13 2022 - 10:06:44 EST


On Wed, Apr 13, 2022 at 03:45:44PM +0200, Krzysztof Kozlowski wrote:
> On 13/04/2022 14:56, Tommaso Merciai wrote:
> > Add pwm1/backlight support nodes for imx8mm_evk board.
> > Align with u-boot dts
> >
>
> Thank you for your patch. There is something to discuss/improve.
>
> >
> > diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> > index 6d67df7692f1..4c18f8fcd377 100644
> > --- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> > +++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> > @@ -59,6 +59,15 @@ reg_usdhc2_vmmc: regulator-usdhc2 {
> > enable-active-high;
> > };
> >
> > + backlight: backlight {
> > + status = "okay";
>
> All nodes have status=okay by default, so no need for this.
>
> > + compatible = "pwm-backlight";
> > + pwms = <&pwm1 0 5000000>;
> > + brightness-levels = <0 255>;
> > + num-interpolated-steps = <255>;
> > + default-brightness-level = <250>;
> > + };
> > +
> > ir-receiver {
> > compatible = "gpio-ir-receiver";
> > gpios = <&gpio1 13 GPIO_ACTIVE_LOW>;
> > @@ -395,6 +404,12 @@ &wdog1 {
> > status = "okay";
> > };
> >
> > +&pwm1 {
> > + pinctrl-names = "default";
> > + pinctrl-0 = <&pinctrl_backlight>;
> > + status = "okay";
>
> This is needed if the node was disabled in DTSI (I did not check it).
>
>
> Best regards,
> Krzysztof

Hi Krzysztof,
Thanks for review, I'll update in v3.

Regards,
Tommaso
--
Tommaso Merciai
Embedded Linux Engineer
tommaso.merciai@xxxxxxxxxxxxxxxxxxxx
__________________________________

Amarula Solutions SRL
Via Le Canevare 30, 31100 Treviso, Veneto, IT
T. +39 042 243 5310
info@xxxxxxxxxxxxxxxxxxxx
www.amarulasolutions.com