Re: [PATCH v5 5/7] net: phy: adin1100: Add initial support for ADIN1100 industrial PHY

[Zhou Furong]

Hi,

> > +static int adin_config_aneg(struct phy_device *phydev)
> > +{
> > +       struct adin_priv *priv = phydev->priv;
> > +       int ret;
> > +
> > +       if (phydev->autoneg == AUTONEG_DISABLE) {
> > +               ret = genphy_c45_pma_setup_forced(phydev);
> > +               if (ret < 0)
> > +                       return ret;
> > +
> > +               if (priv->tx_level_prop_present && priv->tx_level_2v4) {
> > +                       ret = phy_set_bits_mmd(phydev, MDIO_MMD_PMAPMD, MDIO_B10L_PMA_CTRL,
> > +                                              MDIO_PMA_10T1L_CTRL_2V4_EN);
> > +                       if (ret < 0)
> > +                               return ret;
> > +               } else {
> > +                       ret = phy_clear_bits_mmd(phydev, MDIO_MMD_PMAPMD, MDIO_B10L_PMA_CTRL,
> > +                                                MDIO_PMA_10T1L_CTRL_2V4_EN);
> > +                       if (ret < 0)
> > +                               return ret;
> > +               }
move below out if/else

if(ret < 0）
	return ret;


> > +static int adin_set_powerdown_mode(struct phy_device *phydev, bool en)
> > +{
> > +       int ret;
> > +       int val;
> > +
> > +       if (en)
> > +               val = ADIN_CRSM_SFT_PD_CNTRL_EN;
> > +       else
> > +               val = 0;please consider below change which looks neat
           val = en? ADIN_CRSM_SFT_PD_CNTRL_EN : 0


Best regards,
Furong