[V3 3/3] arch: arm64: dts: qcom: Configure cts sleep pinctrl to bias-bus-hold

[Vijaya Krishna Nivarthi]

WLAN rail was leaking power during RBSC/sleep even after turning BT off.
Change sleep pinctrl configuration to handle same.

Signed-off-by: Vijaya Krishna Nivarthi <quic_vnivarth@xxxxxxxxxxx>
---
v3: apply same change to active state and other sc7280*.dts* as well
v2: used bias-bus-hold as per review comments
v1: intial patch used bias-disable for sleep pinctrl in sc7280-idp only
---
 arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi | 13 ++++++++-----
 1 file changed, 8 insertions(+), 5 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi b/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
index b833ba1..602ebd4 100644
--- a/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
@@ -398,8 +398,11 @@ mos_bt_uart: &uart7 {
 
 /* For mos_bt_uart */
 &qup_uart7_cts {
-	/* Configure a pull-down on CTS to match the pull of the Bluetooth module. */
-	bias-pull-down;
+	/*
+	 * Configure a bias-bus-hold on CTS to lower power usage
+	 * when BT is turned off.
+	 */
+	bias-bus-hold;
 };
 
 /* For mos_bt_uart */
@@ -490,10 +493,10 @@ mos_bt_uart: &uart7 {
 		pins = "gpio28";
 		function = "gpio";
 		/*
-		 * Configure a pull-down on CTS to match the pull of
-		 * the Bluetooth module.
+		 * Configure a bias-bus-hold on CTS to lower power usage
+		 * when BT is turned off.
 		 */
-		bias-pull-down;
+		bias-bus-hold;
 	};
 
 	/* For mos_bt_uart */
-- 
Qualcomm INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by the Linux Foundation.