Re: [PATCH V6 3/5] tty: serial: meson: Describes the calculation of the UART baud rate clock using a clock frame

From: Jerome Brunet
Date: Thu Jan 20 2022 - 16:49:59 EST



On Tue 18 Jan 2022 at 10:39, Jiri Slaby <jirislaby@xxxxxxxxxx> wrote:

> On 18. 01. 22, 4:09, Yu Tu wrote:
>> Using the common Clock code to describe the UART baud rate clock
>> makes it easier for the UART driver to be compatible with the
>> baud rate requirements of the UART IP on different meson chips.
> ...
>> --- a/drivers/tty/serial/meson_uart.c
>> +++ b/drivers/tty/serial/meson_uart.c
> ...
>> @@ -629,57 +640,105 @@ static struct uart_driver meson_uart_driver = {
>> .cons = MESON_SERIAL_CONSOLE,
>> };
>> -static inline struct clk *meson_uart_probe_clock(struct device *dev,
>> - const char *id)
>> -{
>> - struct clk *clk = NULL;
>> - int ret;
>> -
>> - clk = devm_clk_get(dev, id);
>> - if (IS_ERR(clk))
>> - return clk;
>> -
>> - ret = clk_prepare_enable(clk);
>> - if (ret) {
>> - dev_err(dev, "couldn't enable clk\n");
>> - return ERR_PTR(ret);
>> - }
>> -
>> - devm_add_action_or_reset(dev,
>> - (void(*)(void *))clk_disable_unprepare,
>> - clk);
>> -
>> - return clk;
>> -}
>> +static struct clk_div_table xtal_div_table[] = {
>
> This can be const, right?
>
>> + {0, 3},
>> + {1, 1},
>> + {2, 2},
>> + {3, 2},
>
> Not sure if you didn't remove too much whitespace. I think it should be
> like: "{ 0, 3 },". But I actually don't care, it's a minor thing.

Seconds
It worth fixing in the next version

>
> I cannot comment on the rest (clk and OF part) as my knowledge is pretty
> limited there. Leaving up to others.
>
> thanks,