[PATCH v2 2/3] staging: pi433: change order in which driver config the rf69 chip

From: Paulo Miguel Almeida
Date: Mon Jan 17 2022 - 01:01:47 EST


There is an explicit dependency between modulation and bit rate
configurations. To ensure proper validation of input value for the
set_bit_rate routine, we must ensure that modulation has been set
before.

This patch ensures that set_modulation is always called before
set_bit_rate for both RX and TX routines

Signed-off-by: Paulo Miguel Almeida <paulo.miguel.almeida.rodenas@xxxxxxxxx>
---
drivers/staging/pi433/pi433_if.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/staging/pi433/pi433_if.c b/drivers/staging/pi433/pi433_if.c
index f9f86e2c44a9..17ff51f6a9da 100644
--- a/drivers/staging/pi433/pi433_if.c
+++ b/drivers/staging/pi433/pi433_if.c
@@ -167,10 +167,10 @@ rf69_set_rx_cfg(struct pi433_device *dev, struct pi433_rx_cfg *rx_cfg)
ret = rf69_set_frequency(dev->spi, rx_cfg->frequency);
if (ret < 0)
return ret;
- ret = rf69_set_bit_rate(dev->spi, rx_cfg->bit_rate);
+ ret = rf69_set_modulation(dev->spi, rx_cfg->modulation);
if (ret < 0)
return ret;
- ret = rf69_set_modulation(dev->spi, rx_cfg->modulation);
+ ret = rf69_set_bit_rate(dev->spi, rx_cfg->bit_rate);
if (ret < 0)
return ret;
ret = rf69_set_antenna_impedance(dev->spi, rx_cfg->antenna_impedance);
@@ -290,10 +290,10 @@ rf69_set_tx_cfg(struct pi433_device *dev, struct pi433_tx_cfg *tx_cfg)
ret = rf69_set_frequency(dev->spi, tx_cfg->frequency);
if (ret < 0)
return ret;
- ret = rf69_set_bit_rate(dev->spi, tx_cfg->bit_rate);
+ ret = rf69_set_modulation(dev->spi, tx_cfg->modulation);
if (ret < 0)
return ret;
- ret = rf69_set_modulation(dev->spi, tx_cfg->modulation);
+ ret = rf69_set_bit_rate(dev->spi, tx_cfg->bit_rate);
if (ret < 0)
return ret;
ret = rf69_set_deviation(dev->spi, tx_cfg->dev_frequency);
--
2.25.4