Re: [PATCH net-next v6] net: phy: intel-xway: Add RGMII internal delay configuration

From: Tim Harvey
Date: Wed Jan 12 2022 - 13:26:54 EST


On Wed, Jan 12, 2022 at 5:46 AM Russell King (Oracle)
<linux@xxxxxxxxxxxxxxx> wrote:
>
> On Tue, Jan 11, 2022 at 11:12:33AM -0800, Tim Harvey wrote:
> > I added a debug statement in xway_gphy_rgmii_init and here you can see
> > it gets called 'before' the link comes up from the NIC on a board that
> > has a cable plugged in at power-on. I can tell from testing that the
> > rx_delay/tx_delay set in xway_gphy_rgmii_init does not actually take
> > effect unless I then bring the link down and up again manually as you
> > indicate.
> >
> > # dmesg | egrep "xway|nicvf"
> > [ 6.855971] xway_gphy_rgmii_init mdio_thunder MDI_MIICTRL:0xb100
> > rx_delay=1500 tx_delay=500
> > [ 6.999651] nicvf, ver 1.0
> > [ 7.002478] nicvf 0000:05:00.1: Adding to iommu group 7
> > [ 7.007785] nicvf 0000:05:00.1: enabling device (0004 -> 0006)
> > [ 7.053189] nicvf 0000:05:00.2: Adding to iommu group 8
> > [ 7.058511] nicvf 0000:05:00.2: enabling device (0004 -> 0006)
> > [ 11.044616] nicvf 0000:05:00.2 eth1: Link is Up 1000 Mbps Full duplex
>
> Does the kernel message about the link coming up reflect what is going
> on physically with the link though?
>
> If a network interface is down, it's entirely possible that the link is
> already established at the hardware level, buit the "Link is Up" message
> gets reported when the network interface is later brought up. So,
> debugging this by looking at the kernel messages is unreliable.
>

Russell,

You are correct... the link doesn't come up at that point its already
linked. So we need to force a reset or an auto negotiation reset after
modifying the delays.

Tim