Re: [PATCH 3/3 v2] arm64: dts: renesas: add MOST device

From: Nikita Yushchenko
Date: Wed Jan 12 2022 - 03:57:21 EST


+ reg = <0 0xec520000 0 0x800>;
+ interrupts = <GIC_SPI 384 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 385 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 386 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 387 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 388 IRQ_TYPE_LEVEL_HIGH>;

What is the purpose of the various interrupts?
Perhaps you need interrupt-names?
The driver seems to use only the first two, which is strange, as
the second and third interrupt handle different channels.

Maybe Christian Gromm (the original driver author) can comment here?

As far as I understand:
- interrupts are: mlb, ahb0, ahb1, ch0rx, ch1rx
- of those, the first 3 are from dim2 itself, and the last two are from renesas-specific logic around dim2
- in the interrupt assignment tables for gen3 SoCs, renesas documents all 5 interrupts, however in the mlb section, renesas mentions only mlb, ahb0 and ch0rx interrupts
- moreover, renesas explicitly denies access dim2 registers responsible for channels 32..63 - which renders ahb1 interrupt useless; and renesas does not document any registers related to "async rx response" on channels 32..63 - which renders chrx1 interrupt useless
- anyway, dim2 driver registers only 32 channels (for all use cases, not only for renesas), and thus uses only ahb0 interrupt
- dim2 driver does not implement renesas-specific processing logic and thus does not use ch0rx interrupt

I'm not sure how to proceed here.
Is it better to define only two interrupts (mlb, ahb0) in device trees?

Regarding 'interrupt-names' - dim2 driver currently uses platform_get_irq() and thus depends on numeric positions (mlb interrupt at index 0 and ahb0 interrupt at index 1). I'm not sure about current use cases of the driver other than with rcar-gen3, and if it is ok to use of_get_irq_byname() instead. And without using of_get_irq_byname(), interrupt-names looks somewhat useless.

But without any DT binding documentation
for this hardware block, this is hard to validate, and not yet ready for
upstream integration.

Christian, are you going to provide DT binding documentation for dim2?

Nikita