Re: [PATCH 1/2] dt-bindings: phy: ti,tcan104x-can: Document mux-states property

[Rob Herring]

On Thu, Dec 02, 2021 at 06:40:01PM +0530, Aswath Govindraju wrote:
> On some boards, for routing CAN signals from controller to transceivers,
> muxes might need to be set. This can be implemented using mux-states
> property. Therefore, document the same in the respective bindings.
> 
> Signed-off-by: Aswath Govindraju <a-govindraju@xxxxxx>
> ---
>  .../devicetree/bindings/phy/ti,tcan104x-can.yaml    | 13 +++++++++++++
>  1 file changed, 13 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
> index 6107880e5246..5b2b08016635 100644
> --- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
> +++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
> @@ -37,6 +37,18 @@ properties:
>        max bit rate supported in bps
>      minimum: 1
>  
> +  mux-states:
> +    description:
> +      mux controller node to route the signals from controller to
> +      transceiver. Depending on the mux chip and the control lines
> +      in it, the first and second parameters can be used for
> +      representing control line and state. The number of arguments
> +      is to be used based on '#mux-state-cells' property in the
> +      mux-controller node. If '#mux-state-cells' is equal to
> +      one then, then the argument to be used would be the state.
> +      If it is set to two, then the first argument is the control
> +      line and the second argument would be its corresponding state.

No need to redefine how a common property works here. What you do need 
to define is how many entries and what they are for if more than 1. 

Rob