Re: earlyprintk=xdbc seems broken

[Mathias Nyman]

On 3.12.2021 2.52, Lu Baolu wrote:
> Hi Peter,
> 
> On 12/2/21 11:22 PM, Peter Zijlstra wrote:
>> Hi Lu,
>>
>> I was unfortunate enough to need xdbc and can't get my machine to boot
>> with earlyprintk=xdbc on the cmdline.
>>
>> When I boot the target without the earlyprintk=xdbc, but have the cable
>> attached, it won't boot because boot gets stuck like:
>>
>> Dec  2 15:08:10 tigerlake kernel: [   42.043137] usb usb4-port3: Cannot enable. Maybe the USB cable is bad?
>> Dec  2 15:08:10 tigerlake kernel: [   42.043227] usb usb4-port3: config error
>>
>> However, when I boot without earlyprintk=xdbc, without the cable
>> attached, then I can attach the cable and:
>>
>> $ echo enable > /sys/bus/pci/devices/0000:00:14.0/dbc
>>
>> will actually work, and it shows up on my host system:
>>
>> [1023855.419430] usb usb2-port3: Cannot enable. Maybe the USB cable is bad?
>> [1023855.419455] usb usb2-port3: config error
>> [1023859.491476] usb usb2-port3: Cannot enable. Maybe the USB cable is bad?
>> [1023859.491487] usb usb2-port3: config error
>> [1023861.335436] usb usb2-port3: config error
>> [1023861.607476] usb 2-3: new SuperSpeed USB device number 7 using xhci_hcd
>> [1023861.627614] usb 2-3: LPM exit latency is zeroed, disabling LPM.
>> [1023861.627853] usb 2-3: New USB device found, idVendor=1d6b, idProduct=0010, bcdDevice= 0.10
>> [1023861.627855] usb 2-3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
>> [1023861.627856] usb 2-3: Product: Linux USB Debug Target
>> [1023861.627857] usb 2-3: Manufacturer: Linux Foundation
>> [1023861.627858] usb 2-3: SerialNumber: 0001
>> [1023861.629344] usb_debug 2-3:1.0: xhci_dbc converter detected
>> [1023861.629532] usb 2-3: xhci_dbc converter now attached to ttyUSB0
>>
>>
>> Can you please see if you can repro and fix this?
>>
>> This all was with current 5.16-rc3 on a tigerlake nuc.
>>
>> Also, perhaps you can update the guide on what sort of setup/cables
>> etc.. you need when either the host or the client is a usb3.1 usb-c only
>> device.
>>
> 
> + Mathias, maybe he still has a USB 3.0 debugging cable.
> 

Should have at the office, I'll pick it up next week and try it out.

-Mathias