Re: [GIT PULL] ARM: at91: soc for 5.15

From: Nicolas Ferre
Date: Wed Aug 04 2021 - 04:20:35 EST


On 04/08/2021 at 10:17, nicolas.ferre@xxxxxxxxxxxxx wrote:
From: Nicolas Ferre <nicolas.ferre@xxxxxxxxxxxxx>

Arnd, Olof,

Here are the soc changes for 5.15 which contains the introduction of our new
SoC family: the SAMA7G5.
Note that one header file is shared with the clock sub-system. We synchronized
with Stephen to make it appear in this Pull-Request.

Thanks, best regards,
Nicolas

The following changes since commit e73f0f0ee7541171d89f2e2491130c7771ba58d3:

Linux 5.14-rc1 (2021-07-11 15:07:40 -0700)

are available in the Git repository at:

git://git.kernel.org/pub/scm/linux/kernel/git/at91/linux.git at91-soc-5.15

for you to fetch changes up to ad9bc2e35cf575644064284943aefdde426644cc:

ARM: at91: pm: add sama7g5 shdwc (2021-07-19 14:32:13 +0200)

----------------------------------------------------------------
AT91 soc for 5.13:
Error with tag, please disregard this message. Sorry for the noise!

Regards,
Nicolas


- Add new SoC based on a Cortex-A7 core: the SAMA7G5 family
- mach-at91 entry, Kconfig and header files
- Power Management Controller (PMC) code and associated power
management changes. Support for suspend/resume, Ultra Low Power modes
and Backup with Memory in Self-Refresh mode.
- Power management association with DDR controller and shutdown
controller for addressing this variety of modes.

----------------------------------------------------------------
Claudiu Beznea (23):
clk: at91: add register definition for sama7g5's master clock
ARM: at91: pm: move pm_bu to soc_pm data structure
ARM: at91: pm: move the setup of soc_pm.bu->suspended
ARM: at91: pm: document at91_soc_pm structure
ARM: at91: pm: check for different controllers in at91_pm_modes_init()
ARM: at91: pm: do not initialize pdev
ARM: at91: pm: use r7 instead of tmp1
ARM: at91: pm: avoid push and pop on stack while memory is in self-refersh
ARM: at91: pm: s/CONFIG_SOC_SAM9X60/CONFIG_HAVE_AT91_SAM9X60_PLL/g
ARM: at91: pm: add support for waiting MCK1..4
ARM: at91: sfrbu: add sfrbu registers definitions for sama7g5
ARM: at91: ddr: add registers definitions for sama7g5's ddr
ARM: at91: pm: add self-refresh support for sama7g5
ARM: at91: pm: add support for MCK1..4 save/restore for ulp modes
ARM: at91: pm: add support for 2.5V LDO regulator control
ARM: at91: pm: wait for ddr power mode off
ARM: at91: pm: add sama7g5 ddr controller
ARM: at91: pm: add sama7g5 ddr phy controller
ARM: at91: pm: save ddr phy calibration data to securam
ARM: at91: pm: add backup mode support for SAMA7G5
ARM: at91: pm: add sama7g5's pmc
ARM: at91: pm: add pm support for SAMA7G5
ARM: at91: pm: add sama7g5 shdwc

Eugen Hristev (3):
ARM: at91: add new SoC sama7g5
ARM: at91: debug: add sama7g5 low level debug uart
ARM: at91: sama7: introduce sama7 SoC family

arch/arm/Kconfig.debug | 10 +
arch/arm/mach-at91/Kconfig | 18 +
arch/arm/mach-at91/Makefile | 1 +
arch/arm/mach-at91/generic.h | 2 +
arch/arm/mach-at91/pm.c | 343 +++++++++++----
arch/arm/mach-at91/pm.h | 3 +
arch/arm/mach-at91/pm_data-offsets.c | 2 +
arch/arm/mach-at91/pm_suspend.S | 827 ++++++++++++++++++++++++++---------
arch/arm/mach-at91/sama7.c | 33 ++
include/linux/clk/at91_pmc.h | 26 ++
include/soc/at91/sama7-ddr.h | 80 ++++
include/soc/at91/sama7-sfrbu.h | 34 ++
12 files changed, 1090 insertions(+), 289 deletions(-)
create mode 100644 arch/arm/mach-at91/sama7.c
create mode 100644 include/soc/at91/sama7-ddr.h
create mode 100644 include/soc/at91/sama7-sfrbu.h



--
Nicolas Ferre