[PATCH 10/25] media: marvel-ccic: fix some issues when getting pm_runtime

From: Mauro Carvalho Chehab
Date: Wed May 05 2021 - 05:43:29 EST


Calling pm_runtime_get_sync() is bad, since even when it
returns an error, pm_runtime_put*() should be called.
So, use instead pm_runtime_resume_and_get().

While here, ensure that the error condition will be checked
during clock enable an media open() calls.

Reviewed-by: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx>
---
drivers/media/platform/marvell-ccic/mcam-core.c | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/media/platform/marvell-ccic/mcam-core.c b/drivers/media/platform/marvell-ccic/mcam-core.c
index 141bf5d97a04..ea87110d9073 100644
--- a/drivers/media/platform/marvell-ccic/mcam-core.c
+++ b/drivers/media/platform/marvell-ccic/mcam-core.c
@@ -918,6 +918,7 @@ static int mclk_enable(struct clk_hw *hw)
struct mcam_camera *cam = container_of(hw, struct mcam_camera, mclk_hw);
int mclk_src;
int mclk_div;
+ int ret;

/*
* Clock the sensor appropriately. Controller clock should
@@ -931,7 +932,9 @@ static int mclk_enable(struct clk_hw *hw)
mclk_div = 2;
}

- pm_runtime_get_sync(cam->dev);
+ ret = pm_runtime_resume_and_get(cam->dev);
+ if (ret < 0)
+ return ret;
clk_enable(cam->clk[0]);
mcam_reg_write(cam, REG_CLKCTRL, (mclk_src << 29) | mclk_div);
mcam_ctlr_power_up(cam);
@@ -1611,7 +1614,9 @@ static int mcam_v4l_open(struct file *filp)
ret = sensor_call(cam, core, s_power, 1);
if (ret)
goto out;
- pm_runtime_get_sync(cam->dev);
+ ret = pm_runtime_resume_and_get(cam->dev);
+ if (ret < 0)
+ goto out;
__mcam_cam_reset(cam);
mcam_set_config_needed(cam, 1);
}
--
2.30.2