Re: [RESEND PATCH] bus: mhi: core: Remove pre_init flag used for power purposes

[Hemant Kumar]

On 4/1/21 2:41 PM, Bhaumik Bhatt wrote:
> Some controllers can choose to skip preparation for power up.
> In that case, device context is initialized based on the pre_init
> flag not being set during mhi_prepare_for_power_up(). There is no
> reason MHI host driver should maintain and provide controllers
> with two separate paths for preparing MHI.
>
> Going forward, all controllers will be required to call the
> mhi_prepare_for_power_up() API followed by their choice of sync
> or async power up. This allows MHI host driver to get rid of the
> pre_init flag and sets up a common way for all controllers to use
> MHI. This also helps controllers fail early on during preparation
> phase in some failure cases.
>
> Signed-off-by: Bhaumik Bhatt <bbhatt@xxxxxxxxxxxxxx>
> ---
> This patch was tested on arm64 architecture.

Change looks good as current MHI controllers ath11k and pci generic are 
not using pre_init.

Reviewed-by: Hemant Kumar <hemantk@xxxxxxxxxxxxxx>

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project