Re: [RFC PATCH 1/2] mm,drm/ttm: Block fast GUP to TTM huge pages

From: Thomas Hellström (Intel)
Date: Thu Mar 25 2021 - 08:37:44 EST



On 3/25/21 1:09 PM, Christian König wrote:
Am 25.03.21 um 13:01 schrieb Jason Gunthorpe:
On Thu, Mar 25, 2021 at 12:53:15PM +0100, Thomas Hellström (Intel) wrote:

Nope. The point here was that in this case, to make sure mmap uses the
correct VA to give us a reasonable chance of alignement, the driver might
need to be aware of and do trickery with the huge page-table-entry sizes
anyway, although I think in most cases a standard helper for this can be
supplied.
Of course the driver needs some way to influence the VA mmap uses,
gernally it should align to the natural page size of the device

Well a mmap() needs to be aligned to the page size of the CPU, but not necessarily to the one of the device.

So I'm pretty sure the device driver should not be involved in any way the choosing of the VA for the CPU mapping.

Christian.

We've had this discussion before and at that time I managed to convince you by pointing to the shmem helper for this, shmem_get_umapped_area().

Basically there are two ways to do this. Either use a standard helper similar to shmem's, and then the driver needs to align physical (device) huge page boundaries to address space offset huge page boundaries. If you don't do that you can just as well use a custom function that adjusts for you not doing that (drm_get_unmapped_area()). Both require driver knowledge of the size of huge pages.

Without a function to adjust, mmap will use it's default (16 byte?) alignment and chance of alignment becomes very small.

/Thomas



Jason