[PATCH 11/13] serial: stm32: add FIFO flush when port is closed

From: Erwan Le Ray
Date: Fri Feb 19 2021 - 12:52:36 EST


Transmission complete error is sent when ISR_TC is not set. If port closure
is requested despite data in TDR / TX FIFO has not been sent (because of
flow control), ISR_TC is not set and error message is sent on port closure
but also when a new port is opened.

Flush the data when port is closed, so the error isn't printed twice upon
next port opening.

Fixes: 64c32eab6603 ("serial: stm32: Add support of TC bit status check")
Signed-off-by: Erwan Le Ray <erwan.leray@xxxxxxxxxxx>

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 45203648172b..dcc309fd5d2f 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -691,6 +691,11 @@ static void stm32_usart_shutdown(struct uart_port *port)
if (ret)
dev_err(port->dev, "Transmission is not complete\n");

+ /* flush RX & TX FIFO */
+ if (ofs->rqr != UNDEF_REG)
+ writel_relaxed(USART_RQR_TXFRQ | USART_RQR_RXFRQ,
+ port->membase + ofs->rqr);
+
stm32_usart_clr_bits(port, ofs->cr1, val);

free_irq(port->irq, port);
--
2.17.1