Re: [PATCH] net: macb: ignore tx_clk if MII is used

[Michael Walle]

Hi Claudiu,

Am 2021-01-21 10:19, schrieb Claudiu.Beznea@xxxxxxxxxxxxx:
> On 20.01.2021 21:43, Michael Walle wrote:
> > EXTERNAL EMAIL: Do not click links or open attachments unless you know 
> > the content is safe
> >
> > If the MII interface is used, the PHY is the clock master, thus don't
> > set the clock rate. On Zynq-7000, this will prevent the following
> > warning:
> >   macb e000b000.ethernet eth0: unable to generate target frequency: 
> > 25000000 Hz
>
> Since in this case the PHY provides the TX clock and it provides the 
> proper
> rate based on link speed, the MACB driver should not handle the 
> bp->tx_clk
> at all (MACB driver uses this clock only for setting the proper rate on 
> it
> based on link speed). So, I believe the proper fix would be to not pass 
> the
> tx_clk at all in device tree. This clock is optional for MACB driver.

Thanks for looking into this.

I had the same thought. But shouldn't the driver handle this case 
gracefully?
I mean it does know that the clock isn't needed at all. Ususually that 
clock
is defined in a device tree include. So you'd have to redefine that node 
in
an actual board file which means duplicating the other clocks.

-michael