Re: [PATCH -next] irq-chip/gic-v3-its: Fixed an issue where the ITS executes the residual commands in the queue again when the ITS wakes up from sleep mode.

From: xuqiang (M)
Date: Thu Nov 05 2020 - 09:06:40 EST



在 2020/11/5 21:12, Marc Zyngier 写道:
Please don't top-post.

On 2020-11-05 11:54, xuqiang (M) wrote:
The kernel sends three commands in the following sequence:

1.mapd(deviceA, ITT_addr1, valid:1)

2.mapti(deviceA):ITS write ITT_addr1 memory;

3.mapd(deviceA, ITT_addr1, valid:0) and kfree(ITT_addr1);

4.mapd(deviceA, ITT_addr2, valid:1);

5.mapti(deviceA):ITS write ITT_addr2 memory;

In this case, the processor enters the sleep mode. After the kernel
performs the suspend operation, the firmware performs the store
operation and saves GITS_CBASER and GITS_CWRITER registers.

Then, the processor is woken up, and the firmware restores GITS_CBASER
and GITS_CWRITER registers. Because GITS_CWRITER register is not 0,
ITS will read the above command sequence execution from the command
queue, causing ITT_addr1 memory to be trampled.

This cannot work. By doing a memset on the command queue, you are
only feeding crap to the ITS (command 0 simply does not exist).
Consider yourself lucky that it doesn't just lock-up.

What needs to happen is the restore sequence that is already in the
driver, so that the command queue is in a sane state before re-enabling
the ITS.

        M.


On my platform, ITS_FLAGS_SAVE_SUSPEND_STATE is not set, thus

the first if condition in its_save_disable under list_for_each_entry goes

to the continue, however, I want to set the GITS_CWRITER to 0 at the

end of list_for_each_entry.

Do you have any suggestions about how to do this?