[PATCH 5.4 07/43] bnxt_en: Avoid sending firmware messages when AER error is detected.

[Greg Kroah-Hartman]

From: Vasundhara Volam <vasundhara-v.volam@xxxxxxxxxxxx>

[ Upstream commit b340dc680ed48dcc05b56e1ebe1b9535813c3ee0 ]

When the driver goes through PCIe AER reset in error state, all
firmware messages will timeout because the PCIe bus is no longer
accessible.  This can lead to AER reset taking many minutes to
complete as each firmware command takes time to timeout.

Define a new macro BNXT_NO_FW_ACCESS() to skip these firmware messages
when either firmware is in fatal error state or when
pci_channel_offline() is true.  It now takes a more reasonable 20 to
30 seconds to complete AER recovery.

Fixes: b4fff2079d10 ("bnxt_en: Do not send firmware messages if firmware is in error state.")
Signed-off-by: Vasundhara Volam <vasundhara-v.volam@xxxxxxxxxxxx>
Signed-off-by: Michael Chan <michael.chan@xxxxxxxxxxxx>
Signed-off-by: Jakub Kicinski <kuba@xxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
 drivers/net/ethernet/broadcom/bnxt/bnxt.c |    6 +++---
 drivers/net/ethernet/broadcom/bnxt/bnxt.h |    4 ++++
 2 files changed, 7 insertions(+), 3 deletions(-)

--- a/drivers/net/ethernet/broadcom/bnxt/bnxt.c
+++ b/drivers/net/ethernet/broadcom/bnxt/bnxt.c
@@ -4204,7 +4204,7 @@ static int bnxt_hwrm_do_send_msg(struct
 	u32 bar_offset = BNXT_GRCPF_REG_CHIMP_COMM;
 	u16 dst = BNXT_HWRM_CHNL_CHIMP;
 
-	if (test_bit(BNXT_STATE_FW_FATAL_COND, &bp->state))
+	if (BNXT_NO_FW_ACCESS(bp))
 		return -EBUSY;
 
 	if (msg_len > BNXT_HWRM_MAX_REQ_LEN) {
@@ -5539,7 +5539,7 @@ static int hwrm_ring_free_send_msg(struc
 	struct hwrm_ring_free_output *resp = bp->hwrm_cmd_resp_addr;
 	u16 error_code;
 
-	if (test_bit(BNXT_STATE_FW_FATAL_COND, &bp->state))
+	if (BNXT_NO_FW_ACCESS(bp))
 		return 0;
 
 	bnxt_hwrm_cmd_hdr_init(bp, &req, HWRM_RING_FREE, cmpl_ring_id, -1);
@@ -7454,7 +7454,7 @@ static int bnxt_set_tpa(struct bnxt *bp,
 
 	if (set_tpa)
 		tpa_flags = bp->flags & BNXT_FLAG_TPA;
-	else if (test_bit(BNXT_STATE_FW_FATAL_COND, &bp->state))
+	else if (BNXT_NO_FW_ACCESS(bp))
 		return 0;
 	for (i = 0; i < bp->nr_vnics; i++) {
 		rc = bnxt_hwrm_vnic_set_tpa(bp, i, tpa_flags);
--- a/drivers/net/ethernet/broadcom/bnxt/bnxt.h
+++ b/drivers/net/ethernet/broadcom/bnxt/bnxt.h
@@ -1628,6 +1628,10 @@ struct bnxt {
 #define BNXT_STATE_ABORT_ERR	5
 #define BNXT_STATE_FW_FATAL_COND	6
 
+#define BNXT_NO_FW_ACCESS(bp)					\
+	(test_bit(BNXT_STATE_FW_FATAL_COND, &(bp)->state) ||	\
+	 pci_channel_offline((bp)->pdev))
+
 	struct bnxt_irq	*irq_tbl;
 	int			total_irqs;
 	u8			mac_addr[ETH_ALEN];