Hi,
On Thu, Sep 10, 2020 at 5:55 AM satya priya <skakit@xxxxxxxxxxxxxx> wrote:
Add a suitable sleep configuration for uart3 to support Bluetooth wakeup.
If QUP function is selected in sleep state, UART RTS/RFR is pulled high
during suspend and BT SoC not able to send wakeup bytes. So, configure
GPIO mode in sleep state to keep it low during suspend.
Signed-off-by: satya priya <skakit@xxxxxxxxxxxxxx>
Reviewed-by: Akash Asthana <akashast@xxxxxxxxxxxxxx>
---
Changes in V2:
- This patch adds sleep state for BT UART. Newly added in V2.
Changes in V3:
- Remove "output-high" for TX from both sleep and default states
as it is not required. Configure pull-up for TX in sleep state.
Changes in V4:
- As per Matthias's comment, removed drive-strength for sleep state
and fixed nit-pick.
Changes in V5:
- As per Matthias's comments, moved pinmux change for sleep state,
pinctrl and interrupt config to the board specific file.
arch/arm64/boot/dts/qcom/sc7180-idp.dts | 48 +++++++++++++++++++++++++++++++++
1 file changed, 48 insertions(+)
Similar comment to patch #1 in that this applies only to the IDP board
but that's not obvious from ${SUBJECT}
diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
index 04888df..e529a41 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts
+++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
@@ -344,6 +344,10 @@
};
&uart3 {
+ pinctrl-names = "default", "sleep";
+ pinctrl-1 = <&qup_uart3_sleep>;
+ interrupts-extended = <&intc GIC_SPI 604 IRQ_TYPE_LEVEL_HIGH>,
+ <&tlmm 41 IRQ_TYPE_EDGE_FALLING>;
You need a:
/delete-property/interrupts;
...or, alternatively, a patch before this one that converts all the
UARTs in sc7180 to just use interrupts-extended.
status = "okay";
Slight nit is that usually I see the status line first. All the other
instances in this file have it that way. Can you match?
-Doug