On Wed, Sep 9, 2020 at 1:31 PM Eddie James <eajames@xxxxxxxxxxxxx> wrote:
Mask the IRQ status to only the bits that the driver checks. ThisSorry, looks like I didn't get my comment in in time.
prevents excessive driver warnings when operating in slave mode
when additional bits are set that the driver doesn't handle.
Signed-off-by: Eddie James <eajames@xxxxxxxxxxxxx>
Reviewed-by: Tao Ren <rentao.bupt@xxxxxxxxx>
Looks good in principle. One minor comment below:
---Could we define ASPEED_I2CD_INTR_RECV_MASK to be ASPEED_I2CD_INTR_ALL ?
drivers/i2c/busses/i2c-aspeed.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/i2c/busses/i2c-aspeed.c b/drivers/i2c/busses/i2c-aspeed.c
index 31268074c422..724bf30600d6 100644
--- a/drivers/i2c/busses/i2c-aspeed.c
+++ b/drivers/i2c/busses/i2c-aspeed.c
@@ -69,6 +69,7 @@
* These share bit definitions, so use the same values for the enable &
* status bits.
*/
+#define ASPEED_I2CD_INTR_RECV_MASK 0xf000ffff
#define ASPEED_I2CD_INTR_SDA_DL_TIMEOUT BIT(14)
#define ASPEED_I2CD_INTR_BUS_RECOVER_DONE BIT(13)
#define ASPEED_I2CD_INTR_SLAVE_MATCH BIT(7)
@@ -604,6 +605,7 @@ static irqreturn_t aspeed_i2c_bus_irq(int irq, void *dev_id)
writel(irq_received & ~ASPEED_I2CD_INTR_RX_DONE,
bus->base + ASPEED_I2C_INTR_STS_REG);
readl(bus->base + ASPEED_I2C_INTR_STS_REG);
+ irq_received &= ASPEED_I2CD_INTR_RECV_MASK;
irq_remaining = irq_received;
#if IS_ENABLED(CONFIG_I2C_SLAVE)
--
2.26.2