Re: [PATCH v2] pinctrl: nsp: Set irq handler based on trig type

From: Ray Jui
Date: Mon Jul 06 2020 - 14:07:21 EST


Hi Mark,

On 7/2/2020 6:18 PM, Mark Tomlinson wrote:
> Rather than always using handle_simple_irq() as the gpio_irq_chip
> handler, set a more appropriate handler based on the IRQ trigger type
> requested. This is important for level triggered interrupts which need
> to be masked during handling. Also, fix the interrupt acknowledge so
> that it clears only one interrupt instead of all interrupts which are
> currently active. Finally there is no need to clear the interrupt during
> the interrupt handler, since the edge-triggered handler will do that for
> us.
>
> Signed-off-by: Mark Tomlinson <mark.tomlinson@xxxxxxxxxxxxxxxxxxx>
> ---
> Changes in v2:
> - Don't perform unnecessary acks.
>
> drivers/pinctrl/bcm/pinctrl-nsp-gpio.c | 18 +++++++++---------
> 1 file changed, 9 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c b/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
> index bed0124388c0..a00a42a61a90 100644
> --- a/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
> +++ b/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
> @@ -154,15 +154,9 @@ static irqreturn_t nsp_gpio_irq_handler(int irq, void *data)
> level &= readl(chip->base + NSP_GPIO_INT_MASK);
> int_bits = level | event;
>
> - for_each_set_bit(bit, &int_bits, gc->ngpio) {
> - /*
> - * Clear the interrupt before invoking the
> - * handler, so we do not leave any window
> - */
> - writel(BIT(bit), chip->base + NSP_GPIO_EVENT);
> + for_each_set_bit(bit, &int_bits, gc->ngpio)
> generic_handle_irq(
> irq_linear_revmap(gc->irq.domain, bit));
> - }
> }
>
> return int_bits ? IRQ_HANDLED : IRQ_NONE;
> @@ -178,7 +172,7 @@ static void nsp_gpio_irq_ack(struct irq_data *d)
>
> trigger_type = irq_get_trigger_type(d->irq);
> if (trigger_type & (IRQ_TYPE_EDGE_FALLING | IRQ_TYPE_EDGE_RISING))
> - nsp_set_bit(chip, REG, NSP_GPIO_EVENT, gpio, val);
> + writel(val, chip->base + NSP_GPIO_EVENT);
> }
>
> /*
> @@ -262,6 +256,12 @@ static int nsp_gpio_irq_set_type(struct irq_data *d, unsigned int type)
>
> nsp_set_bit(chip, REG, NSP_GPIO_EVENT_INT_POLARITY, gpio, falling);
> nsp_set_bit(chip, REG, NSP_GPIO_INT_POLARITY, gpio, level_low);
> +
> + if (type & IRQ_TYPE_EDGE_BOTH)
> + irq_set_handler_locked(d, handle_edge_irq);
> + else
> + irq_set_handler_locked(d, handle_level_irq);
> +
> raw_spin_unlock_irqrestore(&chip->lock, flags);
>
> dev_dbg(chip->dev, "gpio:%u level_low:%s falling:%s\n", gpio,
> @@ -691,7 +691,7 @@ static int nsp_gpio_probe(struct platform_device *pdev)
> girq->num_parents = 0;
> girq->parents = NULL;
> girq->default_type = IRQ_TYPE_NONE;
> - girq->handler = handle_simple_irq;
> + girq->handler = handle_bad_irq;
> }
>
> ret = devm_gpiochip_add_data(dev, gc, chip);
>

This change looks good to me. Thanks!

Reviewed-by: Ray Jui <ray.jui@xxxxxxxxxxxx>