[PATCH 2/9] macintosh/via-macii: Poll the device most likely to respond

From: Finn Thain
Date: Sun Jun 28 2020 - 00:32:06 EST


Poll the most recently polled device by default, rather than the lowest
device address that happens to be enabled in autopoll_devs. This improves
input latency. Re-use macii_queue_poll() rather than duplicate that logic.
This eliminates a static struct and function.

Fixes: d95fd5fce88f0 ("m68k: Mac II ADB fixes") # v5.0+
Tested-by: Stan Johnson <userm57@xxxxxxxxx>
Signed-off-by: Finn Thain <fthain@xxxxxxxxxxxxxxxxxxx>
---
drivers/macintosh/via-macii.c | 99 +++++++++++++++++++----------------
1 file changed, 53 insertions(+), 46 deletions(-)

diff --git a/drivers/macintosh/via-macii.c b/drivers/macintosh/via-macii.c
index 6aa903529570d..d4f1a65c5f1fd 100644
--- a/drivers/macintosh/via-macii.c
+++ b/drivers/macintosh/via-macii.c
@@ -77,6 +77,10 @@ static volatile unsigned char *via;
#define ST_ODD 0x20 /* ADB state: odd data byte */
#define ST_IDLE 0x30 /* ADB state: idle, nothing to send */

+/* ADB command byte structure */
+#define ADDR_MASK 0xF0
+#define CMD_MASK 0x0F
+
static int macii_init_via(void);
static void macii_start(void);
static irqreturn_t macii_interrupt(int irq, void *arg);
@@ -117,7 +121,8 @@ static int reply_len; /* number of bytes received in reply_buf or req->reply */
static int status; /* VIA's ADB status bits captured upon interrupt */
static int last_status; /* status bits as at previous interrupt */
static int srq_asserted; /* have to poll for the device that asserted it */
-static int command_byte; /* the most recent command byte transmitted */
+static u8 last_cmd; /* the most recent command byte transmitted */
+static u8 last_poll_cmd; /* the most recent Talk R0 command byte transmitted */
static int autopoll_devs; /* bits set are device addresses to be polled */

/* Check for MacII style ADB */
@@ -179,35 +184,49 @@ static int macii_init_via(void)
/* Send an ADB poll (Talk Register 0 command prepended to the request queue) */
static void macii_queue_poll(void)
{
- /* No point polling the active device as it will never assert SRQ, so
- * poll the next device in the autopoll list. This could leave us
- * stuck in a polling loop if an unprobed device is asserting SRQ.
- * In theory, that could only happen if a device was plugged in after
- * probing started. Unplugging it again will break the cycle.
- * (Simply polling the next higher device often ends up polling almost
- * every device (after wrapping around), which takes too long.)
- */
- int device_mask;
- int next_device;
static struct adb_request req;
+ unsigned char poll_command;
+ unsigned int poll_addr;

+ /* This only polls devices in the autopoll list, which assumes that
+ * unprobed devices never assert SRQ. That could happen if a device was
+ * plugged in after the adb bus scan. Unplugging it again will resolve
+ * the problem. This behaviour is similar to MacOS.
+ */
if (!autopoll_devs)
return;

- device_mask = (1 << (((command_byte & 0xF0) >> 4) + 1)) - 1;
- if (autopoll_devs & ~device_mask)
- next_device = ffs(autopoll_devs & ~device_mask) - 1;
- else
- next_device = ffs(autopoll_devs) - 1;
+ /* The device most recently polled may not be the best device to poll
+ * right now. Some other device(s) may have signalled SRQ (the active
+ * device won't do that). Or the autopoll list may have been changed.
+ * Try polling the next higher address.
+ */
+ poll_addr = (last_poll_cmd & ADDR_MASK) >> 4;
+ if ((srq_asserted && last_cmd == last_poll_cmd) ||
+ !(autopoll_devs & (1 << poll_addr))) {
+ unsigned int higher_devs;
+
+ higher_devs = autopoll_devs & -(1 << (poll_addr + 1));
+ poll_addr = ffs(higher_devs ? higher_devs : autopoll_devs) - 1;
+ }

- adb_request(&req, NULL, ADBREQ_NOSEND, 1, ADB_READREG(next_device, 0));
+ /* Send a Talk Register 0 command */
+ poll_command = ADB_READREG(poll_addr, 0);
+
+ /* No need to repeat this Talk command. The transceiver will do that
+ * as long as it is idle.
+ */
+ if (poll_command == last_cmd)
+ return;
+
+ adb_request(&req, NULL, ADBREQ_NOSEND, 1, poll_command);

req.sent = 0;
req.complete = 0;
req.reply_len = 0;
req.next = current_req;

- if (current_req != NULL) {
+ if (WARN_ON(current_req)) {
current_req = &req;
} else {
current_req = &req;
@@ -266,37 +285,22 @@ static int macii_write(struct adb_request *req)
/* Start auto-polling */
static int macii_autopoll(int devs)
{
- static struct adb_request req;
unsigned long flags;
- int err = 0;

local_irq_save(flags);

/* bit 1 == device 1, and so on. */
autopoll_devs = devs & 0xFFFE;

- if (autopoll_devs && !current_req) {
- /* Send a Talk Reg 0. The controller will repeatedly transmit
- * this as long as it is idle.
- */
- adb_request(&req, NULL, ADBREQ_NOSEND, 1,
- ADB_READREG(ffs(autopoll_devs) - 1, 0));
- err = macii_write(&req);
+ if (!current_req) {
+ macii_queue_poll();
+ if (current_req && macii_state == idle)
+ macii_start();
}

local_irq_restore(flags);
- return err;
-}

-static inline int need_autopoll(void)
-{
- /* Was the last command Talk Reg 0
- * and is the target on the autopoll list?
- */
- if ((command_byte & 0x0F) == 0x0C &&
- ((1 << ((command_byte & 0xF0) >> 4)) & autopoll_devs))
- return 0;
- return 1;
+ return 0;
}

/* Prod the chip without interrupts */
@@ -333,7 +337,12 @@ static void macii_start(void)
*/

/* store command byte */
- command_byte = req->data[1];
+ last_cmd = req->data[1];
+
+ /* If this is a Talk Register 0 command, store the command byte */
+ if ((last_cmd & CMD_MASK) == ADB_READREG(0, 0))
+ last_poll_cmd = last_cmd;
+
/* Output mode */
via[ACR] |= SR_OUT;
/* Load data */
@@ -424,10 +433,11 @@ static irqreturn_t macii_interrupt(int irq, void *arg)
if (req->done)
(*req->done)(req);

- if (current_req)
+ if (!current_req)
+ macii_queue_poll();
+
+ if (current_req && macii_state == idle)
macii_start();
- else if (need_autopoll())
- macii_autopoll(autopoll_devs);
}

if (macii_state == idle) {
@@ -507,14 +517,11 @@ static irqreturn_t macii_interrupt(int irq, void *arg)

macii_state = idle;

- /* SRQ seen before, initiate poll now */
- if (srq_asserted)
+ if (!current_req)
macii_queue_poll();

if (current_req)
macii_start();
- else if (need_autopoll())
- macii_autopoll(autopoll_devs);

if (macii_state == idle)
via[B] = (via[B] & ~ST_MASK) | ST_IDLE;
--
2.26.2