[PATCH 0/2] serial: qcom_geni_serial: Use the FIFOs properly for console

From: Douglas Anderson
Date: Fri Jun 26 2020 - 16:00:58 EST


This series of two patches gets rid of some ugly hacks that were in
the qcom_geni_serial driver around dealing with a port that was used
for console output and dealing with a port that was being used for
kgdb.

While the character reading/writing code is now slightly more complex,
it's better to be consistently configuring the serial port the same
way and doing so avoids some corner cases where the old hacks weren't
always catching properly.

This change is slightly larger than it needs to be because I was
trying not to use global variables in the read/write functions.
Unfortunately the functions were sometimes called earlycon which
didn't have any "private_data" pointer set. I've tried to do the
minimal change here to have some shared "private_data" that's always
present, but longer term it wouldn't hurt to see if we could unify
more.

Greg / Andy / Bjorn:

This series of patches is atop the current Qualcomm tree to avoid
conflicts. Assuming it looks OK, presumably the best way for it to
land would be to get an Ack from Greg and then Bjorn or Andy could
land it.


Douglas Anderson (2):
serial: qcom_geni_serial: Make kgdb work even if UART isn't console
serial: qcom_geni_serial: Always use 4 bytes per TX FIFO word

drivers/tty/serial/qcom_geni_serial.c | 129 ++++++++++++++++++--------
1 file changed, 88 insertions(+), 41 deletions(-)

--
2.27.0.212.ge8ba1cc988-goog