Re: [PATCH 18/25] mm/riscv: Use mm_fault_accounting()

From: Palmer Dabbelt
Date: Thu Jun 18 2020 - 19:49:28 EST


On Mon, 15 Jun 2020 15:16:00 PDT (-0700), peterx@xxxxxxxxxx wrote:
Use the new mm_fault_accounting() helper for page fault accounting.

Avoid doing page fault accounting multiple times if the page fault is retried.

CC: Paul Walmsley <paul.walmsley@xxxxxxxxxx>
CC: Palmer Dabbelt <palmer@xxxxxxxxxxx>
CC: Albert Ou <aou@xxxxxxxxxxxxxxxxx>
CC: linux-riscv@xxxxxxxxxxxxxxxxxxx
Signed-off-by: Peter Xu <peterx@xxxxxxxxxx>
---
arch/riscv/mm/fault.c | 21 +++------------------
1 file changed, 3 insertions(+), 18 deletions(-)

diff --git a/arch/riscv/mm/fault.c b/arch/riscv/mm/fault.c
index be84e32adc4c..9262338614d1 100644
--- a/arch/riscv/mm/fault.c
+++ b/arch/riscv/mm/fault.c
@@ -30,7 +30,7 @@ asmlinkage void do_page_fault(struct pt_regs *regs)
struct vm_area_struct *vma;
struct mm_struct *mm;
unsigned long addr, cause;
- unsigned int flags = FAULT_FLAG_DEFAULT;
+ unsigned int flags = FAULT_FLAG_DEFAULT, major = 0;
int code = SEGV_MAPERR;
vm_fault_t fault;

@@ -65,9 +65,6 @@ asmlinkage void do_page_fault(struct pt_regs *regs)

if (user_mode(regs))
flags |= FAULT_FLAG_USER;
-
- perf_sw_event(PERF_COUNT_SW_PAGE_FAULTS, 1, regs, addr);
-
retry:
down_read(&mm->mmap_sem);
vma = find_vma(mm, addr);
@@ -111,6 +108,7 @@ asmlinkage void do_page_fault(struct pt_regs *regs)
* the fault.
*/
fault = handle_mm_fault(vma, addr, flags);
+ major |= fault & VM_FAULT_MAJOR;

/*
* If we need to retry but a fatal signal is pending, handle the
@@ -128,21 +126,7 @@ asmlinkage void do_page_fault(struct pt_regs *regs)
BUG();
}

- /*
- * Major/minor page fault accounting is only done on the
- * initial attempt. If we go through a retry, it is extremely
- * likely that the page will be found in page cache at that point.
- */
if (flags & FAULT_FLAG_ALLOW_RETRY) {
- if (fault & VM_FAULT_MAJOR) {
- tsk->maj_flt++;
- perf_sw_event(PERF_COUNT_SW_PAGE_FAULTS_MAJ,
- 1, regs, addr);
- } else {
- tsk->min_flt++;
- perf_sw_event(PERF_COUNT_SW_PAGE_FAULTS_MIN,
- 1, regs, addr);
- }
if (fault & VM_FAULT_RETRY) {
flags |= FAULT_FLAG_TRIED;

@@ -156,6 +140,7 @@ asmlinkage void do_page_fault(struct pt_regs *regs)
}

up_read(&mm->mmap_sem);
+ mm_fault_accounting(tsk, regs, addr, major);
return;

/*

AFAICT this changes the behavior of the perf event: it used to count any fault,
whereas now it only counts those that succeed successfully. If everyone else
is doing it that way then I'm happy to change us over, but this definately
isn't just avoiding retries.