Re: [RFC v1 2/3] drivers: nvmem: Add driver for QTI qfprom-efuse support

From: Srinivas Kandagatla
Date: Thu May 21 2020 - 11:56:24 EST




On 21/05/2020 16:10, Doug Anderson wrote:
On 20/05/2020 23:48, Doug Anderson wrote:
Is this only applicable for corrected address space?
I guess I was proposing a two dts-node / two drive approach here.

dts node #1:just covers the memory range for accessing the FEC-corrected data
driver #1: read-only and reads the FEC-corrected data

dts node #2: covers the memory range that's_not_ the FEC-corrected
memory range.
driver #2: read-write. reading reads uncorrected data

Does that seem sane?
I see your point but it does not make sense to have two node for same thing.
OK, so that sounds as if we want to go with the proposal where we
"deprecate the old driver and/or bindings and say that there really
should just be one node and one driver".

Would this be acceptable to you?

1. Officially mark the old bindings as deprecated.

Possibly Yes for some reasons below!


2. Leave the old driver there to support the old deprecated bindings,
at least until everyone can be transferred over. There seem to be
quite a few existing users of "qcom,qfprom" and we're supposed to make
an attempt at keeping the old device trees working, at least for a
little while. Once everyone is transferred over we could decide to
delete the old driver.
we could consider "qcom,qfrom" to be only passing corrected address space. Till we transition users to new bindings!


Yes.

3. We will have a totally new driver here.
No, we should still be using the same driver. But the exiting driver seems to incorrect and is need of fixing.

Having a look at the memory map for old SoCs like msm8996 and msm8916 shows that memory map that was passed to qfprom driver is corrected address space. Writes will not obviously work!

This should also be true with sdm845 or sc7180

That needs to be fixed first!


4. A given device tree will_not_ be allowed to have both
"qcom,qfprom" specified and "qcom,SOC-qfprom" specified. ...and by
"qcom,SOC-qfprom" I mean that SOC should be replaced by the SoC name,
so "qcom,sc7180-qfprom" or "qcom,sdm845-qfprom". So once you switch
to the new node it replaces the old node.

Secondly, this IP is clearly an integral part of Secure Control Block, which clearly has versioning information.

Versioning information should be part of compatible string in msm8996 it should be "qcom,qfprom-5.1.0"
for msm8916 it should be "qcom,qfprom-4.0.0" this translates to "qcom,qfprom-<MAJOR-NUMBER>-<MINOR-NUMBER>-<STEP>"

Thirdly we should be able to have common read for all these as they tend to just read from corrected address space.

Offsets to corrected address space seems to always constant across SoCs too.

platform specific device tree nodes should also be able to specify "read-only" property to not allow writes on to this raw area.

Does this make sense ?

Thanks,
srini


Isn't the raw address space reads used to for blowing and checking the
fuses if they are blown correctly or not and software usage of these
fuses should only be done from correct address space?

the read interface to user should be always from corrected address space
and write interface should be to raw address space.
Great. That sounds right to me. Presumably the driver could add some
sort of "debugfs" access to read the raw address space if needed.