Re: [RESEND PATCH] arm64: dts: specify console via command line

From: Chunyan Zhang
Date: Thu Mar 12 2020 - 03:35:14 EST


Hi Arnd,

On Wed, 11 Mar 2020 at 22:31, Arnd Bergmann <arnd@xxxxxxxx> wrote:
>
> On Wed, Mar 11, 2020 at 12:21 PM Chunyan Zhang <zhang.lyra@xxxxxxxxx> wrote:
> >
>
> > diff --git a/arch/arm64/boot/dts/sprd/sp9863a-1h10.dts b/arch/arm64/boot/dts/sprd/sp9863a-1h10.dts
> > index 2047f7a74265..510f65f4d8b8 100644
> > --- a/arch/arm64/boot/dts/sprd/sp9863a-1h10.dts
> > +++ b/arch/arm64/boot/dts/sprd/sp9863a-1h10.dts
> > @@ -28,7 +28,7 @@
> >
> > chosen {
> > stdout-path = "serial1:115200n8";
> > - bootargs = "earlycon";
> > + bootargs = "earlycon console=ttyS1";
> > };
> > };
>
> Hi Chunyan,
>
> I would expect that you need to either specify the stdout-path, or the console=
> kernel parameter, but not both.
>

Ok, now I know how to fix the problem without adding 'console=' :)
of_console_check() [1] can tell if a given port is the console by
reading 'stdout-path'.
I will address this issue in serial driver.

Thanks for your reminder,
Chunyan

[1] https://elixir.bootlin.com/linux/v5.6-rc5/source/drivers/of/base.c#L2135

> If earlycon was used, shouldn't the driver know which port is the console?
>
> Arnd