Re: [PATCH net] net: macb: Properly handle phylink on at91rm9200

[Florian Fainelli]

On 2/17/2020 2:43 AM, Alexandre Belloni wrote:
> at91ether_init was handling the phy mode and speed but since the switch to
> phylink, the NCFGR register got overwritten by macb_mac_config().
> 
> Add new phylink callbacks to handle emac and at91rm9200 properly.
> 
> Fixes: 7897b071ac3b ("net: macb: convert to phylink")
> Signed-off-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxx>
> ---

[snip]

> +static void at91ether_mac_link_up(struct phylink_config *config,
> +				  unsigned int mode,
> +				  phy_interface_t interface,
> +				  struct phy_device *phy)
> +{
> +	struct net_device *ndev = to_net_dev(config->dev);
> +	struct macb *bp = netdev_priv(ndev);
> +
> +	/* Enable Rx and Tx */
> +	macb_writel(bp, NCR, macb_readl(bp, NCR) | MACB_BIT(RE) | MACB_BIT(TE));
> +
> +	netif_tx_wake_all_queues(ndev);

So this happens to be copied from the mvpp2 driver, if this is a
requirement, should not this be moved to the phylink implementation
since it already manages the carrier? Those two drivers are the only
ones doing this.
-- 
Florian