Re: [PATCH 3/9] arm64: dts: allwinner: pinebook: Remove unused AXP803 regulators

From: Maxime Ripard
Date: Fri Jan 24 2020 - 11:33:24 EST


On Tue, Jan 21, 2020 at 09:14:02PM -0600, Samuel Holland wrote:
> On 1/21/20 3:05 AM, Maxime Ripard wrote:
> > On Sun, Jan 19, 2020 at 10:30:58AM -0600, Samuel Holland wrote:
> >> The Pinebook does not use the CSI bus on the A64. In fact it does not
> >> use GPIO port E for anything at all. Thus the following regulators are
> >> not used and do not need voltages set:
> >>
> >> - ALDO1: Connected to VCC-PE only
> >> - DLDO3: Not connected
> >> - ELDO3: Not connected
> >>
> >> Signed-off-by: Samuel Holland <samuel@xxxxxxxxxxxx>
> >> ---
> >> .../boot/dts/allwinner/sun50i-a64-pinebook.dts | 16 +---------------
> >> 1 file changed, 1 insertion(+), 15 deletions(-)
> >>
> >> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> >> index ff32ca1a495e..8e7ce6ad28dd 100644
> >> --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> >> +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> >> @@ -202,9 +202,7 @@
> >> };
> >>
> >> &reg_aldo1 {
> >> - regulator-min-microvolt = <2800000>;
> >> - regulator-max-microvolt = <2800000>;
> >> - regulator-name = "vcc-csi";
> >> + regulator-name = "vcc-pe";
> >> };
> >
> > If it's connected to PE, I'd expect the voltage to be at 3.3v?
>
> If we provide voltage constraints, the regulator core will enable the regulator
> and set its voltage at boot. That seems like a bit of a waste.

I'm not sure the regulator core enables them if there's neither
regulator-boot-on nor regulator-always-on.

> I don't think the voltage really matters, since nothing is plugged in to the
> port. ALDO1 can't go over 3.3V anyway, so even if it does get turned on for some
> reason, nothing will get damaged.

Looking at the schematics, it looks like the PE pins are connected to
the front-facing camera?

Maxime