[PATCH v3 7/8] scsi: ufs-qcom: Delay specific time before gate ref clk

[Can Guo]

After enter hibern8, as UFS JEDEC ver 3.0 requires, a specific gating wait
time is required before disable the device reference clock. If it is not
specified, use the old delay.

Signed-off-by: Can Guo <cang@xxxxxxxxxxxxxx>
---
 drivers/scsi/ufs/ufs-qcom.c | 13 ++++++++++---
 1 file changed, 10 insertions(+), 3 deletions(-)

diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
index 85d7c17..3b5b2d9 100644
--- a/drivers/scsi/ufs/ufs-qcom.c
+++ b/drivers/scsi/ufs/ufs-qcom.c
@@ -833,6 +833,8 @@ static int ufs_qcom_bus_register(struct ufs_qcom_host *host)
 
 static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
 {
+	unsigned long gating_wait;
+
 	if (host->dev_ref_clk_ctrl_mmio &&
 	    (enable ^ host->is_dev_ref_clk_enabled)) {
 		u32 temp = readl_relaxed(host->dev_ref_clk_ctrl_mmio);
@@ -845,11 +847,16 @@ static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
 		/*
 		 * If we are here to disable this clock it might be immediately
 		 * after entering into hibern8 in which case we need to make
-		 * sure that device ref_clk is active at least 1us after the
+		 * sure that device ref_clk is active for specific time after
 		 * hibern8 enter.
 		 */
-		if (!enable)
-			udelay(1);
+		if (!enable) {
+			gating_wait = host->hba->dev_info.clk_gating_wait_us;
+			if (!gating_wait)
+				udelay(1);
+			else
+				usleep_range(gating_wait, gating_wait + 10);
+		}
 
 		writel_relaxed(temp, host->dev_ref_clk_ctrl_mmio);
 
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project