[PATCH 2/2] hwmon: (pmbus/ibm-cffps) Fix LED blink behavior

[Eddie James]

The LED blink_set function incorrectly did not tell the PSU LED to blink
if brightness was LED_OFF. Fix this, and also correct the LED_OFF
command data, which should give control of the LED back to the PSU
firmware. Also prevent I2C failures from getting the driver LED state
out of sync and add some dev_dbg statements.

Signed-off-by: Eddie James <eajames@xxxxxxxxxxxxx>
---
 drivers/hwmon/pmbus/ibm-cffps.c | 27 +++++++++++++++++++--------
 1 file changed, 19 insertions(+), 8 deletions(-)

diff --git a/drivers/hwmon/pmbus/ibm-cffps.c b/drivers/hwmon/pmbus/ibm-cffps.c
index c6a00e83aac6..d359b76bcb36 100644
--- a/drivers/hwmon/pmbus/ibm-cffps.c
+++ b/drivers/hwmon/pmbus/ibm-cffps.c
@@ -44,9 +44,13 @@
 #define CFFPS_MFR_VAUX_FAULT			BIT(6)
 #define CFFPS_MFR_CURRENT_SHARE_WARNING		BIT(7)
 
+/*
+ * LED off state actually relinquishes LED control to PSU firmware, so it can
+ * turn on the LED for faults.
+ */
+#define CFFPS_LED_OFF				0
 #define CFFPS_LED_BLINK				BIT(0)
 #define CFFPS_LED_ON				BIT(1)
-#define CFFPS_LED_OFF				BIT(2)
 #define CFFPS_BLINK_RATE_MS			250
 
 enum {
@@ -301,23 +305,31 @@ static int ibm_cffps_led_brightness_set(struct led_classdev *led_cdev,
 					enum led_brightness brightness)
 {
 	int rc;
+	u8 next_led_state;
 	struct ibm_cffps *psu = container_of(led_cdev, struct ibm_cffps, led);
 
 	if (brightness == LED_OFF) {
-		psu->led_state = CFFPS_LED_OFF;
+		next_led_state = CFFPS_LED_OFF;
 	} else {
 		brightness = LED_FULL;
+
 		if (psu->led_state != CFFPS_LED_BLINK)
-			psu->led_state = CFFPS_LED_ON;
+			next_led_state = CFFPS_LED_ON;
+		else
+			next_led_state = CFFPS_LED_BLINK;
 	}
 
+	dev_dbg(&psu->client->dev, "LED brightness set: %d. Command: %d.\n",
+		brightness, next_led_state);
+
 	pmbus_set_page(psu->client, 0);
 
 	rc = i2c_smbus_write_byte_data(psu->client, CFFPS_SYS_CONFIG_CMD,
-				       psu->led_state);
+				       next_led_state);
 	if (rc < 0)
 		return rc;
 
+	psu->led_state = next_led_state;
 	led_cdev->brightness = brightness;
 
 	return 0;
@@ -330,10 +342,7 @@ static int ibm_cffps_led_blink_set(struct led_classdev *led_cdev,
 	int rc;
 	struct ibm_cffps *psu = container_of(led_cdev, struct ibm_cffps, led);
 
-	psu->led_state = CFFPS_LED_BLINK;
-
-	if (led_cdev->brightness == LED_OFF)
-		return 0;
+	dev_dbg(&psu->client->dev, "LED blink set.\n");
 
 	pmbus_set_page(psu->client, 0);
 
@@ -342,6 +351,8 @@ static int ibm_cffps_led_blink_set(struct led_classdev *led_cdev,
 	if (rc < 0)
 		return rc;
 
+	psu->led_state = CFFPS_LED_BLINK;
+	led_cdev->brightness = LED_FULL;
 	*delay_on = CFFPS_BLINK_RATE_MS;
 	*delay_off = CFFPS_BLINK_RATE_MS;
 
-- 
2.23.0