Re: [PATCH 3/6] PCI/PM: Simplify pci_set_power_state()

[Rafael J. Wysocki]

On Fri, Nov 1, 2019 at 9:46 PM Bjorn Helgaas <helgaas@xxxxxxxxxx> wrote:
>
> From: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
>
> Check for the PCI_DEV_FLAGS_NO_D3 quirk early, before calling
> __pci_start_power_transition().  This way all the cases where we don't need
> to do anything at all are checked up front.
>
> This doesn't fix anything because if the caller requested D3hot or D3cold,
> __pci_start_power_transition() is a no-op.  But calling it is pointless and
> makes the code harder to analyze.
>
> Signed-off-by: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>

Reviewed-by: Rafael J. Wysocki <rafael.j.wysocki@xxxxxxxxx>

> ---
>  drivers/pci/pci.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
> index a9d3653ef960..281bc8fc51b3 100644
> --- a/drivers/pci/pci.c
> +++ b/drivers/pci/pci.c
> @@ -1130,8 +1130,6 @@ int pci_set_power_state(struct pci_dev *dev, pci_power_t state)
>         if (dev->current_state == state)
>                 return 0;
>
> -       __pci_start_power_transition(dev, state);
> -
>         /*
>          * This device is quirked not to be put into D3, so don't put it in
>          * D3
> @@ -1139,6 +1137,8 @@ int pci_set_power_state(struct pci_dev *dev, pci_power_t state)
>         if (state >= PCI_D3hot && (dev->dev_flags & PCI_DEV_FLAGS_NO_D3))
>                 return 0;
>
> +       __pci_start_power_transition(dev, state);
> +
>         /*
>          * To put device in D3cold, we put device into D3hot in native
>          * way, then put device into D3cold with platform ops
> --
> 2.24.0.rc1.363.gb1bccd3e3d-goog
>