[PATCH v1] net: phy: at803x: add ar9331 support

[Oleksij Rempel]

Mostly this hardware can work with generic PHY driver, but this change
is needed to provided interrupt handling support.
Tested with dsa ar9331-switch driver.

Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
 drivers/net/phy/at803x.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index 6ad8b1c63c34..d62a77adb8e7 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -53,6 +53,7 @@
 #define AT803X_DEBUG_REG_5			0x05
 #define AT803X_DEBUG_TX_CLK_DLY_EN		BIT(8)
 
+#define AR9331_PHY_ID 0x004dd041
 #define ATH8030_PHY_ID 0x004dd076
 #define ATH8031_PHY_ID 0x004dd074
 #define ATH8035_PHY_ID 0x004dd072
@@ -406,11 +407,24 @@ static struct phy_driver at803x_driver[] = {
 	.aneg_done		= at803x_aneg_done,
 	.ack_interrupt		= &at803x_ack_interrupt,
 	.config_intr		= &at803x_config_intr,
+}, {
+	/* ATHEROS AR9331 */
+	.phy_id			= AR9331_PHY_ID,
+	.name			= "Atheros AR9331 built-in PHY",
+	.phy_id_mask		= AT803X_PHY_ID_MASK,
+	.probe			= at803x_probe,
+	.config_init		= at803x_config_init,
+	.suspend		= at803x_suspend,
+	.resume			= at803x_resume,
+	/* PHY_BASIC_FEATURES */
+	.ack_interrupt		= &at803x_ack_interrupt,
+	.config_intr		= &at803x_config_intr,
 } };
 
 module_phy_driver(at803x_driver);
 
 static struct mdio_device_id __maybe_unused atheros_tbl[] = {
+	{ AR9331_PHY_ID, AT803X_PHY_ID_MASK },
 	{ ATH8030_PHY_ID, AT803X_PHY_ID_MASK },
 	{ ATH8031_PHY_ID, AT803X_PHY_ID_MASK },
 	{ ATH8035_PHY_ID, AT803X_PHY_ID_MASK },
-- 
2.23.0