Re: [PATCH] drm/panel: simple: Doxygenize 'struct panel_desc'; rename a few functions

[Sam Ravnborg]

Hi Doug.

On Wed, Jul 17, 2019 at 07:33:17PM +0200, Sam Ravnborg wrote:
> Hi Doug.
> 
> On Fri, Jul 12, 2019 at 09:33:33AM -0700, Douglas Anderson wrote:
> > This attempts to address outstanding review feedback from commit
> > b8a2948fa2b3 ("drm/panel: simple: Add ability to override typical
> > timing").  Specifically:
> > 
> > * It was requested that I document (in the structure definition) that
> >   the device tree override had no effect if 'struct drm_display_mode'
> >   was used in the panel description.  I have provided full Doxygen
> >   comments for 'struct panel_desc' to accomplish that.
> > * panel_simple_get_fixed_modes() was thought to be a confusing name,
> >   so it has been renamed to panel_simple_get_display_modes().
> > * panel_simple_parse_override_mode() was thought to be better named as
> >   panel_simple_parse_panel_timing_node().
> > 
> > Suggested-by: Sam Ravnborg <sam@xxxxxxxxxxxx>
> > Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
> 
> Thanks.
> 
> I updated the $subject to:
>     drm/panel: simple: document panel_desc; rename a few functions
> 
> And pushed out to drm-misc-next.

I see the following error printed at each boot:

    /panel: could not find node 'panel-timing'

The error originates from this snip (from panel-simple.c):

       if (!of_get_display_timing(dev->of_node, "panel-timing", &dt))
                panel_simple_parse_panel_timing_node(dev, panel, &dt);

of_get_display_timing() returns -2 (-ENOENT).

In the setup I use there is no panel-timing node as the timing specified
in panel-simple.c is fine.
This is the typical setup - and there should not in the normal case
be printed error messages like this during boot.

Will you please take a look at this.

	Sam