Re: [PATCH net-next 4/6] arm64: dts: fsl: ls1028a: Add Felix switch port DT node

[Andrew Lunn]

On Fri, Jun 21, 2019 at 06:38:50PM +0300, Claudiu Manoil wrote:
> The switch device features 6 ports, 4 with external links
> and 2 internally facing to the ls1028a SoC and connected via
> fixed links to 2 internal enetc ethernet controller ports.

Hi Claudiu

> +			switch@0,5 {
> +				compatible = "mscc,felix-switch";
> +				reg = <0x000500 0 0 0 0>;
> +
> +				ethernet-ports {
> +					#address-cells = <1>;
> +					#size-cells = <0>;
> +
> +					/* external ports */
> +					switch_port0: port@0 {
> +						reg = <0>;
> +					};
> +					switch_port1: port@1 {
> +						reg = <1>;
> +					};
> +					switch_port2: port@2 {
> +						reg = <2>;
> +					};
> +					switch_port3: port@3 {
> +						reg = <3>;
> +					};
> +					/* internal to-cpu ports */
> +					port@4 {
> +						reg = <4>;
> +						fixed-link {
> +							speed = <1000>;
> +							full-duplex;
> +						};
> +					};
> +					port@5 {
> +						reg = <5>;
> +						fixed-link {
> +							speed = <1000>;
> +							full-duplex;
> +						};
> +					};
> +				};
> +			};

This sounds like a DSA setup, where you have SoC ports connected to
the switch. With DSA, the CPU ports of the switch are special. We
don't create netdev's for them, the binding explicitly list which SoC
interface they are bound to, etc.

What model are you using here? I'm just trying to understand the setup
to ensure it is consistent with the swichdev model.

   Thanks
	Andrew