Re: [PATCH v3 1/7] drivers: regulator: qcom_spmi: enable linear range info

[Jeffrey Hugo]

On Thu, Jun 13, 2019 at 9:10 AM Bjorn Andersson
<bjorn.andersson@xxxxxxxxxx> wrote:
>
> On Thu 13 Jun 07:22 PDT 2019, Jeffrey Hugo wrote:
>
> > From: Jorge Ramirez-Ortiz <jorge.ramirez-ortiz@xxxxxxxxxx>
> >
> > Signed-off-by: Jorge Ramirez-Ortiz <jorge.ramirez-ortiz@xxxxxxxxxx>
> > Signed-off-by: Jeffrey Hugo <jeffrey.l.hugo@xxxxxxxxx>
> > ---
> >  drivers/regulator/qcom_spmi-regulator.c | 7 +++++++
> >  1 file changed, 7 insertions(+)
> >
> > diff --git a/drivers/regulator/qcom_spmi-regulator.c b/drivers/regulator/qcom_spmi-regulator.c
> > index 53a61fb65642..fd55438c25d6 100644
> > --- a/drivers/regulator/qcom_spmi-regulator.c
> > +++ b/drivers/regulator/qcom_spmi-regulator.c
> > @@ -1744,6 +1744,7 @@ MODULE_DEVICE_TABLE(of, qcom_spmi_regulator_match);
> >  static int qcom_spmi_regulator_probe(struct platform_device *pdev)
> >  {
> >       const struct spmi_regulator_data *reg;
> > +     const struct spmi_voltage_range *range;
> >       const struct of_device_id *match;
> >       struct regulator_config config = { };
> >       struct regulator_dev *rdev;
> > @@ -1833,6 +1834,12 @@ static int qcom_spmi_regulator_probe(struct platform_device *pdev)
> >                       }
> >               }
> >
> > +             if (vreg->logical_type == SPMI_REGULATOR_LOGICAL_TYPE_HFS430) {
>
> This doesn't compile, because HFS430 isn't defined until patch 7.
>
> But in patch 2 you replace this with a check to see if there's just a
> single range, which is a better solution. So squash the last hunk of
> patch 2 into this.

Huh, I did botch that.  The patch 2 hunk was intended to be in patch
1.  Will fix.

>
> Regards,
> Bjorn
>
> > +                     /* since there is only one range */
> > +                     range = spmi_regulator_find_range(vreg);
> > +                     vreg->desc.uV_step = range->step_uV;
> > +             }
> > +
> >               config.dev = dev;
> >               config.driver_data = vreg;
> >               config.regmap = regmap;
> > --
> > 2.17.1
> >