[PATCH v7 04/10] dt-bindings: usb: mtu3: add properties about USB Role Switch

From: Chunfeng Yun
Date: Tue Jun 11 2019 - 04:49:51 EST


Now the USB Role Switch is supported, so add properties about it,
and modify some description related.

Signed-off-by: Chunfeng Yun <chunfeng.yun@xxxxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
---
v7 no changes
v6 no changes

v5 changes:
1. modify decription about extcon and vbus-supply properties
2. make this patch depend on [1]

[1]: [v3] dt-binding: usb: add usb-role-switch property
https://patchwork.kernel.org/patch/10934835/

v4 no changes
v3 no changes

v2 changes:
1. fix typo
2. refer new binding about connector property
---
.../devicetree/bindings/usb/mediatek,mtu3.txt | 10 ++++++++++
1 file changed, 10 insertions(+)

diff --git a/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt b/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt
index 3382b5cb471d..3a8300205cdb 100644
--- a/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt
+++ b/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt
@@ -28,8 +28,13 @@ Optional properties:
parent's address space
- extcon : external connector for vbus and idpin changes detection, needed
when supports dual-role mode.
+ it's considered valid for compatibility reasons, not allowed for
+ new bindings, and use "usb-role-switch" property instead.
- vbus-supply : reference to the VBUS regulator, needed when supports
dual-role mode.
+ it's considered valid for compatibility reasons, not allowed for
+ new bindings, and put into a usb-connector node.
+ see connector/usb-connector.txt.
- pinctrl-names : a pinctrl state named "default" is optional, and need be
defined if auto drd switch is enabled, that means the property dr_mode
is set as "otg", and meanwhile the property "mediatek,enable-manual-drd"
@@ -39,6 +44,8 @@ Optional properties:

- maximum-speed : valid arguments are "super-speed", "high-speed" and
"full-speed"; refer to usb/generic.txt
+ - usb-role-switch : use USB Role Switch to support dual-role switch, but
+ not extcon; see usb/generic.txt.
- enable-manual-drd : supports manual dual-role switch via debugfs; usually
used when receptacle is TYPE-A and also wants to support dual-role
mode.
@@ -61,6 +68,9 @@ The xhci should be added as subnode to mtu3 as shown in the following example
if host mode is enabled. The DT binding details of xhci can be found in:
Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.txt

+The port would be added as subnode if use "usb-role-switch" property.
+ see graph.txt
+
Example:
ssusb: usb@11271000 {
compatible = "mediatek,mt8173-mtu3";
--
2.21.0