Re: [PATCH 1/4] ARM: dts: imx6: RDU2: Use new CODEC reset pin name

[Shawn Guo]

On Fri, Mar 29, 2019 at 01:13:10PM -0500, Andrew F. Davis wrote:
> The correct DT property for specifying a GPIO used for reset
> is "reset-gpios", the driver now accepts this name, use it here.
> 
> Note the GPIO polarity in the driver was ignored before and always
> assumed to be active low, when all the DTs are fixed we will start
> respecting the specified polarity. Switch polarity in DT to the
> currently assumed one, this way when the driver changes the
> behavior will not change.
> 
> Signed-off-by: Andrew F. Davis <afd@xxxxxx>

I fixed up the prefix to use board name, and applied patch #1 ~ #3.

Shawn