[PATCH v4 0/2] Add support for MIPID02 CSI-2 to PARALLEL bridge I2C device

From: Mickael Guene
Date: Wed Mar 27 2019 - 05:56:28 EST


Hi,

This is the v4 of my MIPID02 series which introduces support of
STMicroelectronics MIPID02 CSI-2 to PARALLEL I2C bridge. It allows using a CSI-2
sensor with a PARALLEL interface. Current driver implementation doesn't support
CSI-2 second input port usage. It doesn't support also YUV420, RGB565 and RGB444
input formats.

Thanks to Sakari for review.

Changes in v4:
- Fix and clarify endpoints properties documentation
- Add support of enum_mbus_code
- Only use V4L2_CID_PIXEL_RATE to compute link speed
- Use MEDIA_BUS_FMT_UYVY8_1X16 instead of MEDIA_BUS_FMT_UYVY8_2X8 for CSI-2 link
- Fix miscellaneous typos
- Fix wrong code behavior for set_fmt and get_fmt

Changes in v3:
- Fix potential wrong error code for mipid02_stream_disable and mipid02_stream_enable
- Remove useless memset for ep in mipid02_parse_rx_ep and mipid02_parse_tx_ep
- Add second CSI-2 input pad even if it's not yet supported
- Add support of get_fmt, set_fmt and link_validate and only access subdev connected to mipid02

Changes in v2:
- Add precision about first CSI-2 port data rate
- Document endpoints supported properties
- Rename 'mipid02@14' into generic 'csi2rx@14' in example
- Merge MAINTAINERS patch 3 into patch 1 and 2
- Fix line too long in Kconfig
- Add missing delay after reset release
- Various style fixes
- Fix mipid02_stream_enable returning no error when mipid02_find_sensor failed

Mickael Guene (2):
dt-bindings: Document MIPID02 bindings
media:st-mipid02: MIPID02 CSI-2 to PARALLEL bridge driver

.../bindings/media/i2c/st,st-mipid02.txt | 82 ++
MAINTAINERS | 8 +
drivers/media/i2c/Kconfig | 14 +
drivers/media/i2c/Makefile | 1 +
drivers/media/i2c/st-mipid02.c | 1043 ++++++++++++++++++++
5 files changed, 1148 insertions(+)
create mode 100644 Documentation/devicetree/bindings/media/i2c/st,st-mipid02.txt
create mode 100644 drivers/media/i2c/st-mipid02.c

--
2.7.4