Re: [PATCH 05/12] PCI: aardvark: add suspend to RAM support

From: Lorenzo Pieralisi
Date: Mon Dec 03 2018 - 05:27:19 EST


[+Rafael, Sudeep]

On Fri, Nov 23, 2018 at 03:18:24PM +0100, Miquel Raynal wrote:
> Add suspend and resume callbacks. The priority of these are
> "_noirq()", to workaround early access to the registers done by the
> PCI core through the ->read()/->write() callbacks at resume time.
>
> Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
> ---
> drivers/pci/controller/pci-aardvark.c | 52 +++++++++++++++++++++++++++
> 1 file changed, 52 insertions(+)
>
> diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
> index 108b3f15c410..7ecf1ac4036b 100644
> --- a/drivers/pci/controller/pci-aardvark.c
> +++ b/drivers/pci/controller/pci-aardvark.c
> @@ -1108,6 +1108,55 @@ static int advk_pcie_setup_clk(struct advk_pcie *pcie)
> return ret;
> }
>
> +static int __maybe_unused advk_pcie_suspend(struct device *dev)
> +{
> + struct advk_pcie *pcie = dev_get_drvdata(dev);
> +
> + advk_pcie_disable_phy(pcie);
> +
> + clk_disable_unprepare(pcie->clk);

I have noticed it is common practice, still, I would like to check whether
it is allowed to call functions that may sleep in a NOIRQ suspend/resume
callback ?

Thanks,
Lorenzo

> +
> + return 0;
> +}
> +
> +static int __maybe_unused advk_pcie_resume(struct device *dev)
> +{
> + struct advk_pcie *pcie = dev_get_drvdata(dev);
> + int ret;
> +
> + ret = clk_prepare_enable(pcie->clk);
> + if (ret)
> + return ret;
> +
> + /*
> + * Empirical delay needed after enabling the clock and before
> + * accessing any register.
> + */
> + msleep(10);
> +
> + ret = advk_pcie_enable_phy(pcie);
> + if (ret)
> + return ret;
> +
> + advk_pcie_hard_reset(pcie);
> +
> + advk_pcie_setup_hw(pcie);
> +
> + advk_sw_pci_bridge_init(pcie);
> +
> + return 0;
> +}
> +
> +/*
> + * The PCI core will try to reconfigure the bus quite early in the resume path.
> + * We must use the _noirq() alternatives to ensure the controller is ready when
> + * the core uses the ->read()/->write() callbacks.
> + */
> +static const struct dev_pm_ops advk_pcie_dev_pm_ops = {
> + SET_NOIRQ_SYSTEM_SLEEP_PM_OPS(advk_pcie_suspend,
> + advk_pcie_resume)
> +};
> +
> static int advk_pcie_probe(struct platform_device *pdev)
> {
> struct device *dev = &pdev->dev;
> @@ -1188,6 +1237,8 @@ static int advk_pcie_probe(struct platform_device *pdev)
> return ret;
> }
>
> + dev_set_drvdata(dev, pcie);
> +
> return 0;
> }
>
> @@ -1200,6 +1251,7 @@ static struct platform_driver advk_pcie_driver = {
> .driver = {
> .name = "advk-pcie",
> .of_match_table = advk_pcie_of_match_table,
> + .pm = &advk_pcie_dev_pm_ops,
> /* Driver unloading/unbinding currently not supported */
> .suppress_bind_attrs = true,
> },
> --
> 2.19.1
>