RE: [PATCH v4 1/7] spi: add support for octo mode I/O data transfer
From: Yogesh Narayan Gaur
Date: Mon Dec 03 2018 - 03:47:54 EST
Hi Boris,
> -----Original Message-----
> From: Boris Brezillon [mailto:boris.brezillon@xxxxxxxxxxx]
> Sent: Monday, December 3, 2018 1:35 PM
> To: Yogesh Narayan Gaur <yogeshnarayan.gaur@xxxxxxx>;
> broonie@xxxxxxxxxx
> Cc: linux-mtd@xxxxxxxxxxxxxxxxxxx; marek.vasut@xxxxxxxxx; vigneshr@xxxxxx;
> linux-spi@xxxxxxxxxxxxxxx; devicetree@xxxxxxxxxxxxxxx; robh@xxxxxxxxxx;
> mark.rutland@xxxxxxx; shawnguo@xxxxxxxxxx; linux-arm-
> kernel@xxxxxxxxxxxxxxxxxxx; computersforpeace@xxxxxxxxx;
> frieder.schrempf@xxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx
> Subject: Re: [PATCH v4 1/7] spi: add support for octo mode I/O data transfer
>
> Hi Yogesh,
>
> On Thu, 22 Nov 2018 05:14:31 +0000
> Yogesh Narayan Gaur <yogeshnarayan.gaur@xxxxxxx> wrote:
>
> > Add flags for Octo mode I/O data transfer Required for the SPI
> > controller which can do the data transfer (TX/RX) on 8 data lines e.g.
> > NXP FlexSPI controller.
> > SPI_TX_OCTO: transmit with 8 wires
> > SPI_RX_OCTO: receive with 8 wires
> >
> > Signed-off-by: Yogesh Gaur <yogeshnarayan.gaur@xxxxxxx>
> > Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx>
> > ---
> > Changes for v4:
> > - Rebase on top of v4.20-rc2
> > Changes for v3:
> > - Modified string 'octal' with 'octo'.
>
> When I listed the differences between your version and mine, I mentioned the
> OCTO vs OCTAL name, but I didn't say my decision was the correct one :-). Looks
> like OCTAL is the term employed almost everywhere, and it's also consistent
> with DUAL. Would you mind sending a new version reverting the name to OCTAL.
>
Next version of patch series send [1]
--
Regards,
Yogesh Gaur
[1] https://patchwork.ozlabs.org/project/linux-mtd/list/?series=79338
[...]