Re: [PATCH V2 2/2] mmc: mmci: add variant property to send stop cmd if a command fail

From: Ulf Hansson
Date: Wed Nov 21 2018 - 12:56:56 EST


On 7 November 2018 at 10:30, Ludovic Barre <ludovic.Barre@xxxxxx> wrote:
> From: Ludovic Barre <ludovic.barre@xxxxxx>
>
> The mmc framework follows the requirement of SD_Specification:
> the STOP_TRANSMISSION is sent on multiple write/read commands
> and the stop command (alone), not needed on other ADTC commands.
>
> But, if an error happens on command or data transmission, some
> variants require a stop command "STOP_TRANSMISION" to clear the DPSM
> "Data Path State Machine". If it's not done the next data
> command freezes hardware block.
> Needed to support the STM32 sdmmc variant.

May I suggest some re-wording of this changelog, as to make it more
clear of why this is needed. Something along the lines of:

"The current approach with sending a CMD12 (STOP_TRANSMISSION) to
complete a data transfer request, either because of using the open
ended transmission type or because of receiving an error during a data
transfer, isn't sufficient for the STM32 sdmmc variant.

More precisely, for STM32 sdmmc the DPSM ("Data Path State Machine" )
needs to be cleared by sending a CMD12, also for the so called ADTC
commands. For this reason, add a new mmci variant property and let the
driver send a CMD12 to complete ADTC commands, in case it's set."

>
> Signed-off-by: Ludovic Barre <ludovic.barre@xxxxxx>
> ---
> drivers/mmc/host/mmci.c | 33 +++++++++++++++++++++++++++++++++
> drivers/mmc/host/mmci.h | 4 ++++
> 2 files changed, 37 insertions(+)
>
> diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
> index 13fa640..47b865d 100644
> --- a/drivers/mmc/host/mmci.c
> +++ b/drivers/mmc/host/mmci.c
> @@ -21,6 +21,7 @@
> #include <linux/err.h>
> #include <linux/highmem.h>
> #include <linux/log2.h>
> +#include <linux/mmc/mmc.h>
> #include <linux/mmc/pm.h>
> #include <linux/mmc/host.h>
> #include <linux/mmc/card.h>
> @@ -57,6 +58,8 @@ void sdmmc_variant_init(struct mmci_host *host);
> #else
> static inline void sdmmc_variant_init(struct mmci_host *host) {}
> #endif
> +static void
> +mmci_start_command(struct mmci_host *host, struct mmc_command *cmd, u32 c);
>
> static unsigned int fmax = 515633;
>
> @@ -274,6 +277,7 @@ static struct variant_data variant_stm32_sdmmc = {
> .cmdreg_lrsp_crc = MCI_CPSM_STM32_LRSP_CRC,
> .cmdreg_srsp_crc = MCI_CPSM_STM32_SRSP_CRC,
> .cmdreg_srsp = MCI_CPSM_STM32_SRSP,
> + .cmdreg_stop = MCI_CPSM_STM32_CMDSTOP,
> .data_cmd_enable = MCI_CPSM_STM32_CMDTRANS,
> .irq_pio_mask = MCI_IRQ_PIO_STM32_MASK,
> .datactrl_first = true,
> @@ -573,6 +577,24 @@ void mmci_dma_error(struct mmci_host *host)
> static void
> mmci_request_end(struct mmci_host *host, struct mmc_request *mrq)
> {
> + /*
> + * If an error happens on command or data transmission, some variants
> + * require a stop command to reinit the DPSM.
> + * If it's not done the next data command freeze hardware block.
> + */
> + if (host->variant->cmdreg_stop) {
> + u32 dpsm;
> +
> + dpsm = readl_relaxed(host->base + MMCISTATUS);
> + dpsm &= MCI_STM32_DPSMACTIVE;
> +
> + if (dpsm && ((mrq->cmd && mrq->cmd->error) ||
> + (mrq->data && mrq->data->error))) {
> + mmci_start_command(host, &host->stop_abort, 0);
> + return;
> + }

I would rather move this code to a separate function. Also, I think
you need something else (or additional) than polling the MMCISTATUS
register, as in principle you could end up sending CMD12 several times
for the same request, which isn't correct.

To me the best solution would probably be to make use of the
host->data pointer, as it becomes set when DPSM has been enabled.
However, host->data is also cleared in mmci_stop_data() which is being
called prior mmci_request_end(). In other words, we need to figure
under what conditions the new code above should be triggered/called
and then also change the conditions for when mmci_request_end() shall
be called.

In principle look at callers of mmci_request_end() and
mmci_stop_data() and update those paths.

> + }
> +
> writel(0, host->base + MMCICOMMAND);
>
> BUG_ON(host->data);
> @@ -1100,6 +1122,10 @@ mmci_start_command(struct mmci_host *host, struct mmc_command *cmd, u32 c)
> mmci_reg_delay(host);
> }
>
> + if (host->variant->cmdreg_stop &&
> + cmd->opcode == MMC_STOP_TRANSMISSION)
> + c |= host->variant->cmdreg_stop;
> +

Hmm.

It looks like the above changes, together with the introduction of the
variant property, belongs in a separate patch, preceding $subject
patch in the series.

The reason is, that to me, it makes sense to add the special treatment
of the ADTC commands in a separate patch. Can you please split it up
and then of course update the change log accordingly!?

> c |= cmd->opcode | host->variant->cmdreg_cpsm_enable;
> if (cmd->flags & MMC_RSP_PRESENT) {
> if (cmd->flags & MMC_RSP_136)
> @@ -1950,6 +1976,13 @@ static int mmci_probe(struct amba_device *dev,
> mmc->max_busy_timeout = 0;
> }
>
> + /* prepare the stop command, used to abort and reinitialized the DPSM */
> + if (variant->cmdreg_stop) {
> + host->stop_abort.opcode = MMC_STOP_TRANSMISSION;
> + host->stop_abort.arg = 0;
> + host->stop_abort.flags = MMC_RSP_R1B | MMC_CMD_AC;
> + }
> +
> mmc->ops = &mmci_ops;
>
> /* We support these PM capabilities. */
> diff --git a/drivers/mmc/host/mmci.h b/drivers/mmc/host/mmci.h
> index 550dd39..35372cd 100644
> --- a/drivers/mmc/host/mmci.h
> +++ b/drivers/mmc/host/mmci.h
> @@ -161,6 +161,7 @@
> #define MCI_ST_CEATAEND (1 << 23)
> #define MCI_ST_CARDBUSY (1 << 24)
> /* Extended status bits for the STM32 variants */
> +#define MCI_STM32_DPSMACTIVE BIT(12)
> #define MCI_STM32_BUSYD0 BIT(20)
>
> #define MMCICLEAR 0x038
> @@ -264,6 +265,7 @@ struct mmci_host;
> * @cmdreg_lrsp_crc: enable value for long response with crc
> * @cmdreg_srsp_crc: enable value for short response with crc
> * @cmdreg_srsp: enable value for short response without crc
> + * @cmdreg_stop: enable value for stop and abort transmission
> * @datalength_bits: number of bits in the MMCIDATALENGTH register
> * @fifosize: number of bytes that can be written when MMCI_TXFIFOEMPTY
> * is asserted (likewise for RX)
> @@ -316,6 +318,7 @@ struct variant_data {
> unsigned int cmdreg_lrsp_crc;
> unsigned int cmdreg_srsp_crc;
> unsigned int cmdreg_srsp;
> + unsigned int cmdreg_stop;
> unsigned int datalength_bits;
> unsigned int fifosize;
> unsigned int fifohalfsize;
> @@ -375,6 +378,7 @@ struct mmci_host {
> void __iomem *base;
> struct mmc_request *mrq;
> struct mmc_command *cmd;
> + struct mmc_command stop_abort;
> struct mmc_data *data;
> struct mmc_host *mmc;
> struct clk *clk;
> --
> 2.7.4
>

Kind regards
Uffe