Re: [PATCH] mmc: add quirk for O2 Micro dev 0x8620 rev 0x01

From: Ulf Hansson
Date: Thu Sep 27 2018 - 08:12:08 EST


On 27 September 2018 at 03:40, Yu Zhao <yuzhao@xxxxxxxxxx> wrote:
> On Thu, Sep 27, 2018 at 01:48:58AM +0200, Ulf Hansson wrote:
>> On 23 September 2018 at 22:39, Yu Zhao <yuzhao@xxxxxxxxxx> wrote:
>> > This device reports SDHCI_CLOCK_INT_STABLE even though it's not
>> > ready to take SDHCI_CLOCK_CARD_EN. The symptom is that reading
>> > SDHCI_CLOCK_CONTROL after enabling the clock shows absence of the
>> > bit from the register (e.g. expecting 0x0000fa07 = 0x0000fa03 |
>> > SDHCI_CLOCK_CARD_EN but only observed the first operand).
>> >
>> > mmc1: Timeout waiting for hardware cmd interrupt.
>> > mmc1: sdhci: ============ SDHCI REGISTER DUMP ===========
>> > mmc1: sdhci: Sys addr: 0x00000000 | Version: 0x00000603
>> > mmc1: sdhci: Blk size: 0x00000000 | Blk cnt: 0x00000000
>> > mmc1: sdhci: Argument: 0x00000000 | Trn mode: 0x00000000
>> > mmc1: sdhci: Present: 0x01ff0001 | Host ctl: 0x00000001
>> > mmc1: sdhci: Power: 0x0000000f | Blk gap: 0x00000000
>> > mmc1: sdhci: Wake-up: 0x00000000 | Clock: 0x0000fa03
>> > mmc1: sdhci: Timeout: 0x00000000 | Int stat: 0x00000000
>> > mmc1: sdhci: Int enab: 0x00ff0083 | Sig enab: 0x00ff0083
>> > mmc1: sdhci: AC12 err: 0x00000000 | Slot int: 0x00000000
>> > mmc1: sdhci: Caps: 0x25fcc8bf | Caps_1: 0x00002077
>> > mmc1: sdhci: Cmd: 0x00000000 | Max curr: 0x005800c8
>> > mmc1: sdhci: Resp[0]: 0x00000000 | Resp[1]: 0x00000000
>> > mmc1: sdhci: Resp[2]: 0x00000000 | Resp[3]: 0x00000000
>> > mmc1: sdhci: Host ctl2: 0x00000008
>> > mmc1: sdhci: ADMA Err: 0x00000000 | ADMA Ptr: 0x00000000
>> > mmc1: sdhci: ============================================
>> >
>> > The problem happens during wakeup from S3. Adding a delay quirk
>> > after power up reliably fixes the problem.
>> >
>> > Signed-off-by: Yu Zhao <yuzhao@xxxxxxxxxx>
>>
>> Applied for next, thanks!
>>
>> Kind regards
>> Uffe
>>
>> > ---
>> > drivers/mmc/host/sdhci-pci-o2micro.c | 2 ++
>> > 1 file changed, 2 insertions(+)
>> >
>> > diff --git a/drivers/mmc/host/sdhci-pci-o2micro.c b/drivers/mmc/host/sdhci-pci-o2micro.c
>> > index 77e9bc4aaee9..3e5ecf7ce101 100644
>> > --- a/drivers/mmc/host/sdhci-pci-o2micro.c
>> > +++ b/drivers/mmc/host/sdhci-pci-o2micro.c
>> > @@ -490,6 +490,8 @@ int sdhci_pci_o2_probe(struct sdhci_pci_chip *chip)
>> > pci_write_config_byte(chip->pdev, O2_SD_LOCK_WP, scratch);
>> > break;
>> > case PCI_DEVICE_ID_O2_SEABIRD0:
>> > + if (chip->pdev->revision == 0x01)
>> > + chip->quirks |= SDHCI_QUIRK_DELAY_AFTER_POWER;
>
> Hi Uffe,
>
> I apologize for the missing /* fall through */ here. Could you
> please add it in case it causes any static checker problem?
> Or I can send a v2.

I amended the change, no action needed. Thanks!

Kind regards
Uffe