[PATCH v3] spi: dw: support 4-16 bits per word

From: Simon Goldschmidt
Date: Tue Sep 04 2018 - 15:50:31 EST


The spi-dw driver currently only supports 8 or 16 bits per word.

Since the hardware supports 4-16 bits per word, adapt the driver
to also support this.

Tested on socfpga cyclone5 with a 9-bit SPI display.

Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@xxxxxxxxx>
Reviewed-by: Andy Shevchenko <andy.shevchenko@xxxxxxxxx>
---
Changes in v3
- remove the check for valid 'bits_per_word' from dw_spi_transfer_one()
- add reviewed-by tag

Changes in v2:
- use DIV_ROUND_UP to calculate number of bytes per word instead of
if/else range checks

drivers/spi/spi-dw.c | 16 +++++++---------
1 file changed, 7 insertions(+), 9 deletions(-)

diff --git a/drivers/spi/spi-dw.c b/drivers/spi/spi-dw.c
index f693bfe95ab9..58a7caf31d59 100644
--- a/drivers/spi/spi-dw.c
+++ b/drivers/spi/spi-dw.c
@@ -307,15 +307,10 @@ static int dw_spi_transfer_one(struct spi_controller *master,
dws->current_freq = transfer->speed_hz;
spi_set_clk(dws, chip->clk_div);
}
- if (transfer->bits_per_word == 8) {
- dws->n_bytes = 1;
- dws->dma_width = 1;
- } else if (transfer->bits_per_word == 16) {
- dws->n_bytes = 2;
- dws->dma_width = 2;
- } else {
- return -EINVAL;
- }
+
+ dws->n_bytes = DIV_ROUND_UP(transfer->bits_per_word, BITS_PER_BYTE);
+ dws->dma_width = DIV_ROUND_UP(transfer->bits_per_word, BITS_PER_BYTE);
+
/* Default SPI mode is SCPOL = 0, SCPH = 0 */
cr0 = (transfer->bits_per_word - 1)
| (chip->type << SPI_FRF_OFFSET)
@@ -493,7 +491,7 @@ int dw_spi_add_host(struct device *dev, struct dw_spi *dws)
}

master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_LOOP;
- master->bits_per_word_mask = SPI_BPW_MASK(8) | SPI_BPW_MASK(16);
+ master->bits_per_word_mask = SPI_BPW_RANGE_MASK(4, 16);
master->bus_num = dws->bus_num;
master->num_chipselect = dws->num_cs;
master->setup = dw_spi_setup;
--
2.17.1