Re: [PATCH v3 1/3] Input: atmel_mxt_ts: Add support for optional regulators.

[George G. Davis]

Hello PaweÅ,


I would suggest dropping sentence punctuation in the patch subject line:

Input: atmel_mxt_ts: Add support for optional regulators.

More below...

On Tue, Jul 31, 2018 at 05:18:09PM +0200, PaweÅ Chmiel wrote:
> This patch adds optional regulators, which can be used to power
> up touchscreen. After enabling regulators, we need to wait 150msec.
> This value is taken from official driver.
> 
> It was tested on Samsung Galaxy i9000 (based on Samsung S5PV210 SOC).
> 
> Signed-off-by: PaweÅ Chmiel <pawel.mikolaj.chmiel@xxxxxxxxx>
> ---
> Changes from v2:
>   - Move code enabling regulators into separate method,
>     to make code more readable.
> 
> Changes from v1:
>   - Enable regulators only if reset_gpio is present.
>   - Switch from devm_regulator_get_optional to devm_regulator_get
> ---
>  drivers/input/touchscreen/atmel_mxt_ts.c | 65 +++++++++++++++++++++++++++++---
>  1 file changed, 59 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/input/touchscreen/atmel_mxt_ts.c b/drivers/input/touchscreen/atmel_mxt_ts.c
> index 54fe190fd4bc..2cd7f6db6ba9 100644
> --- a/drivers/input/touchscreen/atmel_mxt_ts.c
> +++ b/drivers/input/touchscreen/atmel_mxt_ts.c
> @@ -27,6 +27,7 @@
>  #include <linux/interrupt.h>
>  #include <linux/of.h>
>  #include <linux/property.h>
> +#include <linux/regulator/consumer.h>
>  #include <linux/slab.h>
>  #include <linux/gpio/consumer.h>
>  #include <linux/property.h>
> @@ -194,10 +195,10 @@ enum t100_type {
>  
>  /* Delay times */
>  #define MXT_BACKUP_TIME		50	/* msec */
> -#define MXT_RESET_GPIO_TIME	20	/* msec */
>  #define MXT_RESET_INVALID_CHG	100	/* msec */
>  #define MXT_RESET_TIME		200	/* msec */
>  #define MXT_RESET_TIMEOUT	3000	/* msec */
> +#define MXT_REGULATOR_DELAY	150	/* msec */
>  #define MXT_CRC_TIMEOUT		1000	/* msec */
>  #define MXT_FW_RESET_TIME	3000	/* msec */
>  #define MXT_FW_CHG_TIMEOUT	300	/* msec */
> @@ -310,6 +311,8 @@ struct mxt_data {
>  	struct t7_config t7_cfg;
>  	struct mxt_dbg dbg;
>  	struct gpio_desc *reset_gpio;
> +	struct regulator *vdd_reg;
> +	struct regulator *avdd_reg;
>  
>  	/* Cached parameters from object table */
>  	u16 T5_address;
> @@ -3016,6 +3019,38 @@ static const struct dmi_system_id chromebook_T9_suspend_dmi[] = {
>  	{ }
>  };
>  
> +static int mxt_regulator_enable(struct mxt_data *data)
> +{
> +	int error;
> +
> +	if (data->reset_gpio) {
> +		error = regulator_enable(data->vdd_reg);
> +		if (error) {
> +			dev_err(&data->client->dev, "Failed to enable vdd regulator: %d\n",
> +				error);
> +			return error;
> +		}
> +
> +		error = regulator_enable(data->avdd_reg);
> +		if (error) {
> +			dev_err(&data->client->dev, "Failed to enable avdd regulator: %d\n",
> +				error);
> +			return error;
> +		}
> +
> +		/*
> +		 * According to maXTouch power sequencing specification, RESET line

Please fix the following checkpatch issue:

drivers/input/touchscreen/atmel_mxt_ts.c:3065: WARNING:LONG_LINE_COMMENT: line over 80 characters

Thanks!

--
Regards,
George

> +		 * must be kept low until some time after regulators come up to
> +		 * voltage
> +		 */
> +		msleep(MXT_REGULATOR_DELAY);
> +		gpiod_set_value(data->reset_gpio, 1);
> +		msleep(MXT_RESET_INVALID_CHG);
> +	}
> +
> +	return 0;
> +}
> +
>  static int mxt_probe(struct i2c_client *client, const struct i2c_device_id *id)
>  {
>  	struct mxt_data *data;
> @@ -3076,6 +3111,22 @@ static int mxt_probe(struct i2c_client *client, const struct i2c_device_id *id)
>  		return error;
>  	}
>  
> +	data->vdd_reg = devm_regulator_get(&client->dev, "vdd");
> +	if (IS_ERR(data->vdd_reg)) {
> +		error = PTR_ERR(data->vdd_reg);
> +		dev_err(&client->dev, "Failed to get vdd regulator: %d\n",
> +			error);
> +		return error;
> +	}
> +
> +	data->avdd_reg = devm_regulator_get(&client->dev, "avdd");
> +	if (IS_ERR(data->avdd_reg)) {
> +		error = PTR_ERR(data->avdd_reg);
> +		dev_err(&client->dev, "Failed to get avdd regulator: %d\n",
> +			error);
> +		return error;
> +	}
> +
>  	error = devm_request_threaded_irq(&client->dev, client->irq,
>  					  NULL, mxt_interrupt, IRQF_ONESHOT,
>  					  client->name, data);
> @@ -3086,11 +3137,9 @@ static int mxt_probe(struct i2c_client *client, const struct i2c_device_id *id)
>  
>  	disable_irq(client->irq);
>  
> -	if (data->reset_gpio) {
> -		msleep(MXT_RESET_GPIO_TIME);
> -		gpiod_set_value(data->reset_gpio, 1);
> -		msleep(MXT_RESET_INVALID_CHG);
> -	}
> +	error = mxt_regulator_enable(data);
> +	if (error)
> +		return error;
>  
>  	error = mxt_initialize(data);
>  	if (error)
> @@ -3116,6 +3165,10 @@ static int mxt_remove(struct i2c_client *client)
>  	struct mxt_data *data = i2c_get_clientdata(client);
>  
>  	disable_irq(data->irq);
> +	if (data->reset_gpio) {
> +		regulator_disable(data->avdd_reg);
> +		regulator_disable(data->vdd_reg);
> +	}
>  	sysfs_remove_group(&client->dev.kobj, &mxt_attr_group);
>  	mxt_free_input_device(data);
>  	mxt_free_object_table(data);
> -- 
> 2.7.4
> 
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel