Re: [PATCH] lightnvm: pblk: assume that chunks are closed on 1.2 devices

From: Matias BjÃrling
Date: Tue Jun 26 2018 - 07:44:40 EST


On 06/26/2018 01:31 PM, Hans Holmberg wrote:
On Tue, Jun 26, 2018 at 1:38 PM, Matias BjÃrling <mb@xxxxxxxxxxx> wrote:
On 06/26/2018 11:37 AM, Javier Gonzalez wrote:



On 26 Jun 2018, at 10.41, Matias BjÃrling <mb@xxxxxxxxxxx> wrote:

On 06/19/2018 11:06 AM, Hans Holmberg wrote:

From: Hans Holmberg <hans.holmberg@xxxxxxxxxxxx>
We can't know if a block is closed or not on 1.2 devices, so assume
closed state to make sure that blocks are erased before writing.
Fixes: 32ef9412c114 ("lightnvm: pblk: implement get log report chunk")
Signed-off-by: Hans Holmberg <hans.holmberg@xxxxxxxxxxxx>
---
This patch applies on:
ssh://github.com/OpenChannelSSD/linux branch for-4.19/core
drivers/lightnvm/pblk-init.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/lightnvm/pblk-init.c b/drivers/lightnvm/pblk-init.c
index aa24264..3b8aa4a 100644
--- a/drivers/lightnvm/pblk-init.c
+++ b/drivers/lightnvm/pblk-init.c
@@ -717,10 +717,11 @@ static int pblk_setup_line_meta_12(struct pblk
*pblk, struct pblk_line *line,
/*
* In 1.2 spec. chunk state is not persisted by the
device. Thus
- * some of the values are reset each time pblk is
instantiated.
+ * some of the values are reset each time pblk is
instantiated,
+ * so we have to assume that the block is closed.
*/
if (lun_bb_meta[line->id] == NVM_BLK_T_FREE)
- chunk->state = NVM_CHK_ST_FREE;
+ chunk->state = NVM_CHK_ST_CLOSED;
else
chunk->state = NVM_CHK_ST_OFFLINE;


pblk should scan (or the lightnvm subsystem) the blocks for their
state, such that it doesn't have to reinitialize a full drive if it is
already in a closed state. If marking closed, it does a full erase
cycle on initialization, which should be avoided since it is a limited
resource.


In 1.2 there is no such state unfortunately. However, pblk will never
attempt to reinitialize the whole drive - metadata for closed blocks
will be recovered and only those going to GC will be erased before
usage. In fact, a full close drive is the state pblk expects.

This patch only affects "unknown blocks", thus the only case in which
pblk would attempt to double erase is when blocks have been pre-erased
(e.g., factory or through liblightnvm). After an erase round though,
pblk will only erase pre-usage. One thing we could do is attempting to
read the first page of these unknown blocks and mark them as free if
"empty page" is returned. Is this what you mean?


Yes, that is what I mean.

Note that this can be

costly on large drives; this is the reason we returned to the pre-2.0
behaviour with this patch. We are implementing a log that, among other
things, keeps the state so that pblk can have an accurate state for the
cases this can be a problem.


Yep, it will take some time. Good to hear with the log.

Until we have a log in place, this patch unbreaks 1.2 support and has
no negative impact on performance (as compared to pre 2.0 support), so
please consider it for the next window.
The current state is that if a pblk instance is created on a 1.2 disk
with written blocks, writes will fail.

/ Hans


The negative impact is that all blocks are erased, even if they are in free state. This is a showstopper. We cannot throw out 1/X of the lifetime of the drive on each initialization. The 1.2 spec is made such that a scan can recover the block state accurately.