Re: [PATCH v4 03/15] dt-bindings: qcom_nandc: update for ECC strength and step size

[Rob Herring]

On Wed, Jun 20, 2018 at 12:57:30PM +0530, Abhishek Sahu wrote:
> 1. If nand-ecc-strength specified in DT, then controller will use
>    this ECC strength otherwise ECC strength will be calculated
>    according to chip requirement and available OOB size.
> 
> 2. QCOM NAND controller supports only one step size (512 bytes) but
>    nand-ecc-step-size is required property in DT. This DT property
>    can be removed and ecc step size can be assigned in driver with
>    512 bytes value.
> 
> Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx>
> ---
> 
> * Changes from v3:
> 
> 1. Clubbed following 2 patches into one
>    https://patchwork.ozlabs.org/patch/920465/
>    https://patchwork.ozlabs.org/patch/920467/
> 
> * Changes from v2:
>   NONE
> 
> * Changes from v1:
>   NEW PATCH
> 
>  Documentation/devicetree/bindings/mtd/qcom_nandc.txt | 7 +++----
>  1 file changed, 3 insertions(+), 4 deletions(-)

Reviewed-by: Rob Herring <robh@xxxxxxxxxx>