Re: [PATCH v2] ARM: dts: imx51-zii-rdu1: Make sure SD1_WP is low

[Shawn Guo]

On Fri, May 25, 2018 at 07:12:38PM -0700, Andrey Smirnov wrote:
> Make sure that MX51_PAD_GPIO1_1 does not remain configure as
> ALT0/SD1_WP (it is out of reset). This is needed because of external
> pull-up resistor attached to that pad that, when left unchanged, will
> drive SD1_WP high preventing eSDHC1/eMMC from working correctly.
> 
> To fix that add a pinmux configuration line configureing the pad to
> function as a GPIO. While we are at it, add a corresponding
> output-high GPIO hog in an effort to minimize current consumption.
> 
> Cc: Nikita Yushchenko <nikita.yoush@xxxxxxxxxxxxxxxxxx>
> Cc: Shawn Guo <shawnguo@xxxxxxxxxx>
> Cc: Fabio Estevam <fabio.estevam@xxxxxxx>
> Cc: Lucas Stach <l.stach@xxxxxxxxxxxxxx>
> Cc: Chris Healy <cphealy@xxxxxxxxx>
> Cc: Rob Herring <robh+dt@xxxxxxxxxx>
> Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> Cc: devicetree@xxxxxxxxxxxxxxx
> Cc: linux-kernel@xxxxxxxxxxxxxxx
> Signed-off-by: Andrey Smirnov <andrew.smirnov@xxxxxxxxx>

Applied, thanks.