[PATCH] regulator: of: add property for allowed modes specification

From: David Collins
Date: Fri May 11 2018 - 21:46:46 EST


Add a common device tree property for regulator nodes to support
the specification of allowed operating modes.

Signed-off-by: David Collins <collinsd@xxxxxxxxxxxxxx>
Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
---
Documentation/devicetree/bindings/regulator/regulator.txt | 5 +++++
1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt
index 2babe15b618d..c627aa08f0da 100644
--- a/Documentation/devicetree/bindings/regulator/regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/regulator.txt
@@ -59,6 +59,11 @@ Optional properties:
- regulator-initial-mode: initial operating mode. The set of possible operating
modes depends on the capabilities of every hardware so each device binding
documentation explains which values the regulator supports.
+- regulator-allowed-modes: list of operating modes that software is allowed to
+ configure for the regulator at run-time. Elements may be specified in any
+ order. The set of possible operating modes depends on the capabilities of
+ every hardware so each device binding document explains which values the
+ regulator supports.
- regulator-system-load: Load in uA present on regulator that is not captured by
any consumer request.
- regulator-pull-down: Enable pull down resistor when the regulator is disabled.
--
2.17.0